Sagaris vents

[Don1]

I really like the look of Claires Sag, and was wondering how much it would cost to get the vents cut out properly, and lined with mesh....

Anyone have any ideas?

[Lensey]

I think I remember the figure of about £1100? I'm sure someone will be along soon that will know?

[blackiepaul]

£1,700 but it is not with mesh but specially made drainage, not sure what they are made from but they are black. I was meant to have mine fitted with them by Paul Seymore from X works but I could not make it to blackpool becaue of diff problems. I will be getting it done in the new year.

If you are a member of TVROC then you can see RPA Janwells on the link below. You will also see it on the Sagaris register.

http://www.tvr-car-club.co.uk/forum/forum_posts.as...

Hope that helps

[KillerJim]

Whats to stop anyone (during a respray) from cutting out the vents and adding some drainage blow the vents (again bit of custom plastic work) for a holder and drainage tube..

Only issue I can think about is getting into the wheel arches to add in the plastic / drainages stuff...

[shaunsmith]

Paul did mine last year did a superb job. The Sagaris doesn't look right with blocked vents, the vents alone were integral to the car when I saw the prototype years ago & was dissapointed TVR filled them in.

[Don1]

Cheers all....

[KillerJim]

shaunsmith said:

Paul did mine last year did a superb job. The Sagaris doesn't look right with blocked vents, the vents alone were integral to the car when I saw the prototype years ago & was dissapointed TVR filled them in.

Dito, I was also disappointed they made the bonnet smaller too - i think the wide bonnet with the vents 1/2 way on the bonnet and 1/2 on thw wing looked far nicer..

J

[D14 AYS]

KillerJim said:

Dito, I was also disappointed they made the bonnet smaller too - i think the wide bonnet with the vents 1/2 way on the bonnet and 1/2 on the wing looked far nicer..

I agree the bigger bonnet was the business

[the jollyrodger]

for bob.