wheel bearings again

[gsx600]

Well got my press yesterday and managed to remove the uj's easily enough.

But still having issues with the rear wheel bearing.

Can someone confirm the following before I head to the loft for the bible

Bearing is pushed out from the back ? (seems to be 2 cutouts where I could fashion a piece of metal to sit in and push on these)

No circlip at front holding it in ?

Will maybe try oven ready method and then try and push out again with gas torch as extra heat source if needed

[gsx600]

Well after burning the crap of whilst heating, I found a circlip, bugger to get off but eventually off and bent

Bearing out now, just waiting for the new one now, but anyone know where the circlip comes from if I fail to hammer it straight ?

[tempus]

Should be a new one in the new bearing box, Tempus

[mac123yre]

am about to do mine i take it its a left hand thread?

[gsx600]

No iI think they are both normal thread, hence why pinned to stop coming undone !

[mac123yre]

Thanks