Removing lower veneer radio panel
Removing lower veneer radio panel
Author
Discussion

AlRaven

Original Poster:

408 posts

240 months

Wednesday 14th January 2009
quotequote all
I've got a tiny chip in this panel which annoys me so I'mm going to get french polisher type guy to fix, however all of them want the part out of the car. Anything in particular I should watch out for when removing this? (I am totally cack-handed).

K4TRV

1,819 posts

283 months

Wednesday 14th January 2009
quotequote all
I'm intrigued. The metal panel has a veneer stuck to it. How could a French polisher "fill-in". Can understand a wooden table and a "mark" or a "repair" to that ??

Anyway, if you have an early model (93 to 95-ish ??), then the following should apply (or get the Bible ??).

You remove your radio. There are 2 screws left and right of the radio apature. Remove them. The panel can then move forward (towards you). There are plugs to be removed to allow the wiring harness to come with the panel.

You then have to "remove" the switches from the metal back plate. You are then left with the plate and stuck-in plastic indicators.

Hope that helps.

Trev

chrispitman

742 posts

285 months

Wednesday 14th January 2009
quotequote all
To remove you need to take the radio out, which can be a tight fit. Remove the radio cage then either side of the radio are two screws remove these then the panel should come out. Make a note of which way round the connectors go.

Bensonv8

470 posts

240 months

Thursday 15th January 2009
quotequote all
idea Label ALL the wires CLEARLY BEFORE you unplug anything.
Better still take photo's

I didn't, then spent several hours trying to work out where they all went. confused