Rear Brake Pads Chim - Straightforward Fitting ?
Discussion
I plan to fit my own rear upgraded brake pads on Chim 500 to match the front pads/discs completed easily last year.
I have read somewhere this is not a straightforward job on the rear. Can anyone on here confirm what sort of job this and why this may be not for the home mechanic? Is there a probelm with rear handrake mechanism?
Any advice appreciate or an idiots guide most welcome before i start.
I have read somewhere this is not a straightforward job on the rear. Can anyone on here confirm what sort of job this and why this may be not for the home mechanic? Is there a probelm with rear handrake mechanism?
Any advice appreciate or an idiots guide most welcome before i start.
I agree with Dog, get the tool, you can borrow mine if you want to come to Winchester and pick it up. Otherwise no big deal. The Bible has instructions, as would a Haynes mid 90's Sierra manual, but to be honest it's pretty straight forward if you've done brakes before. Also use EZ Bleed, another great tool.
Just did this job on my 400 HC. Top tip: Buy a calliper piston wind-back tool and wind the calliper piston in CLOCKWISE. I was uncertain and started winding one calliper piston anti-clockwise, this let in some air and meant that I had to bleed the entire braking system. It did take an age to wind the piston in correctly as well, even with the piston winding tool!
Apart from that the job wasn't too bad.
Apart from that the job wasn't too bad.
Quinny said:
spend said:
My wind back tool puts the pressure on as well, but I never use that part of it, just open the bleed valve & dump the crap boiled fluid at the same time 
My wind back tool is a pair of pipe grips


Hence the G clamp


Pasco said:
Quinny said:
f
k off, I've got an adjustable spanner, and a lever, that turns into a screwdriver (or is that a screwdriver that turns into a lever??)
Either way I have a full tookit thankyou very much
Which Ain't much good according to your Misses you Old Git !!!
k off, I've got an adjustable spanner, and a lever, that turns into a screwdriver (or is that a screwdriver that turns into a lever??)Either way I have a full tookit thankyou very much


x 10000000000 Mrs P said the same about you tubbs

Gassing Station | Chimaera | Top of Page | What's New | My Stuff




