Oil Leak Bell Housing!
Oil Leak Bell Housing!
Author
Discussion

bjarkes

Original Poster:

122 posts

215 months

Monday 19th January 2009
quotequote all
Just bought my first Chim and also got the "Bibel" and read about oil leak from the crankshaft. I notice in the garage that my car is driping a small amount of oil from the bell housing (T5 box), how big a problem is this, is the clutch going to die soon? The clutch is working perfekt.

Edited by bjarkes on Monday 19th January 20:44

GreenV8S

31,027 posts

315 months

Monday 19th January 2009
quotequote all
Oil leaks all over the place can find their way to the bell housing so I wouldn't jump to any nasty conclusions. A few drops here or there is just going to help keep the rust down. It's when you start seeing puddles in the floor you need to worry! smile

spend

12,581 posts

282 months

Monday 19th January 2009
quotequote all
Check the rocker gaskets & back of the sump gasket firstly wink

fastandcurious

437 posts

239 months

Monday 19th January 2009
quotequote all
When I first got my Griff It had an oil leak that was being thrown back onto the bell housing. All the sump bolts were loose. I tightened them up and It stopped.

chr1sb

126 posts

235 months

Tuesday 20th January 2009
quotequote all
Could be the gearbox seal - I've had that one.

Chris

bjarkes

Original Poster:

122 posts

215 months

Tuesday 20th January 2009
quotequote all
But should I worrie about the clutch getting oil?

WOO5IE

967 posts

228 months

Tuesday 20th January 2009
quotequote all
Hi BJ

If you remove the rubber sealon the bell housing , if you have one, and the oil is not inside then the leak must be coming from outide the bell housing. Therefore the clutch should be safe. If it is inside then it could be the crankshaft seal with potential of hitting the clutch. More likely to be rocker cover/sump as previously mentioned.

A lot of cars have this rubber bung missing

Home this helps

Trev

spend

12,581 posts

282 months

Tuesday 20th January 2009
quotequote all
Both bellhousings (LT77 or T5 box) should have drainage, you may want to pull of the inspection cover of the T5.

The rear bearing & cruciform seal are very rare failures, many more cases of them being incorrectly diagnosed IMHO wink Thats the only place oil could be getting in to the bellhousing unless one of the oil blanking plugs has failed (unheard of?) that I can think of.

Carefully (again & again - can't stress enough) wipe all surfaces to trace where the oil is coming from, its very hard to tell as it will always collect at the bottom of the bellhousing after running down surfaces wink

That Daddy

19,464 posts

252 months

Tuesday 20th January 2009
quotequote all
chr1sb said:
Could be the gearbox seal - I've had that one.

Chris
yes mine as been weeping from here since i purchased the car over 3 years ago,i will change mine when the clutch needs replacing,oh leaks from the input shaft seal appear to miss the clutch assy so dont panic,well mine as.