wiper gear fix?
Discussion
After 7 months hard work, the chim is back on the road this weekend. showing off her new out riggers.
However, something id forgotten about was, the wipers or rather lack of.
i had an issue where only the wipers were crap, i changed the plate in thew wiper motor, the park switch and the cable drive, and still found the drivers side would not wipe but rather would sit still, this i now think, is the wiper wheel box?
if it is, how easy or hard is it to change these little blitters? as from looking at it, i cant really even see how you gain access to them to change
anyone know? also, what car are the wheel units from, as normal ones are priced around the £15 mark, but clever trevor are quoting £39each for them


However, something id forgotten about was, the wipers or rather lack of.
i had an issue where only the wipers were crap, i changed the plate in thew wiper motor, the park switch and the cable drive, and still found the drivers side would not wipe but rather would sit still, this i now think, is the wiper wheel box?
if it is, how easy or hard is it to change these little blitters? as from looking at it, i cant really even see how you gain access to them to change
anyone know? also, what car are the wheel units from, as normal ones are priced around the £15 mark, but clever trevor are quoting £39each for them



Edited by T_Pot on Thursday 22 January 22:13
If CT list them as individual parts, that's a bonus as they only ever used to be obtainable as part of a motor and drive kit. Acces on mine was by removing the dash top and then through a letterbox sized hatch in the bulkhead under the screen. Not much room to work as always and a lot of jiggling and swearing to remove/refit. I actually 'repaired' mine by judiciously reforming the housings (pressed steel) so that the cable was held in closer contact with the gear teeth. I did stick a new drive cable in though that was a cut down version of one supplied by a SVC, a classic Lucas specialist (a temporary fix might be possible by rotating the cable at the motor by 180 degrees as they can wear flat and you then introduce a fresh profile to mesh).
Have read that the hatch is not always present but I'm unsure that even TVR would bond the body up around something so prone to falling to bits...
Have read that the hatch is not always present but I'm unsure that even TVR would bond the body up around something so prone to falling to bits...
Edited by Pupp on Thursday 22 January 23:48
Meant to add I never did match the wheels to any other vehicle, they are very similar to lots of old classic stuff but different in terms of spindle threads and gland angles etc. I still have some from a Wolsley or something that were the closest I managed in case they can be modified/canibalised.
Hi, have read in a previous post that the hatch is not always there, depends on age, what peeps said was you have to cut a hatch yourself then cut a plate out of mild steel and mastic it over hatch you have cut, but where to cut it for best access I dont know, try a search on wipers maybe, sorry cant help more.
well, ive had the dash top off, and no surprise, i have no hatch.
went to order the £39 part, and found a further £9 delivery charge, so didnt order it and now looking to see if i can source one elsewhere.
getting very very cheesed off with the prices for parts for this car.
£9 delivery for a small light part is enough to send me off the edge now. i know its only £9, but principle and all that
went to order the £39 part, and found a further £9 delivery charge, so didnt order it and now looking to see if i can source one elsewhere.
getting very very cheesed off with the prices for parts for this car.
£9 delivery for a small light part is enough to send me off the edge now. i know its only £9, but principle and all that
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


