imola 16" wheels on the front.
imola 16" wheels on the front.
Author
Discussion

Halfman

Original Poster:

65 posts

271 months

Sunday 25th January 2009
quotequote all
I know this probably has been asked many times before but i can't seem to find a definite answer using the seach. If I want to put a pair of 16" rear wheels on the front what tyres sizes would be most suited for both front and rear?

Many thanks.
Richard

350Matt

3,914 posts

310 months

Sunday 25th January 2009
quotequote all
Hello

teh last griff had 16" rims front and rear and used 225/45 on the front and 245/45s on the back, I wouldn't fit the same width front to rear as the cars tend to oversteer enough as it is!

Matt

Halfman

Original Poster:

65 posts

271 months

Monday 26th January 2009
quotequote all
Thanks wil give them a try.

chrispitman

742 posts

285 months

Tuesday 27th January 2009
quotequote all
I have 16" all round with 225/45 front and 245/45 rear. Remember you will need to fit some rack stops as one of the fronts will hit the wish bone on 16"'s

spend

12,581 posts

282 months

Tuesday 27th January 2009
quotequote all
chrispitman said:
I have 16" all round with 225/45 front and 245/45 rear. Remember you will need to fit some rack stops as one of the fronts will hit the wish bone on 16"'s
Many have said they didn't need them, but I agree that fitting them is a no brainer. Only if you check all angles at all travels of suspension for clearance (and over & over again if you change any geo settings..) would I be tempted not to fit them.

K4TRV

1,819 posts

283 months

Tuesday 27th January 2009
quotequote all
If you're planning to use rear Imolas, the offset for the front is wrong.

The fronts need to be et25,so if you have an et33 (Imola rear),then you ought to use a spacer of 8 or 10mm to get it back to the et25 offset.

This then throws into question the length of your studs,ie are they still long enough? I think usually they are still ok with an 8mm spacer,but check!

You should also take the Spend suggestions of checking clearance as well, or obviously !!

spend

12,581 posts

282 months

Tuesday 27th January 2009
quotequote all
I think thats the rub, either fit stops and narrow the footprint C/L slightly (wheels are wider IIRC) or fit spacers + studs and widen the tracking. This is more than likely the reason for the differing reports on the application of stops / spacers?

lwt

316 posts

315 months

Tuesday 27th January 2009
quotequote all
I have 16" fronts with 225 and 16" rears with 245. A simpler alternative to rack stops are wheel spacers. From experience I know that these only need to be 3mm thick so no need to change wheel studs. Spacers are around £10 for a pair, I got mine from rallydesign in Faversham.

Ian.

Halfman

Original Poster:

65 posts

271 months

Tuesday 27th January 2009
quotequote all
Thanks for your thoughts gents, I certainly appreciate your help.