Wortec Stripes...
Discussion
Thanks Devil. Didn't take too long. I did it mostly by eye at first to see where I wanted them, then measured up to keep it consistent and symetrical on both sides, marked it up with tape as a guide and went for it. I then slowly peeled off the back and applied in sections from back to front so I knew I got "wortec" in the right place. It was a bit scary at first, but it is quite forgiving on first application.
I think you're usually meant to use the water and squeegy trick, but I went in dry (that's not like me
) after giving the car a good cleaning.
Once on, I removed the protective cover on the front and noticed a few tiny bubbles so I gently peeled a section back and then very carefully smoothed it back down with the edge of my palm from the inside out to get the bubbles out.
Originally I tried to find a sign writers to do it for me, but nowhere was open and I got impatient. Probably not the way you're meant to do it, but worked out nicely though.
I think you're usually meant to use the water and squeegy trick, but I went in dry (that's not like me
) after giving the car a good cleaning. Once on, I removed the protective cover on the front and noticed a few tiny bubbles so I gently peeled a section back and then very carefully smoothed it back down with the edge of my palm from the inside out to get the bubbles out.
Originally I tried to find a sign writers to do it for me, but nowhere was open and I got impatient. Probably not the way you're meant to do it, but worked out nicely though.
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff