Discussion
Picked up my fist TVR today, HOORAY
It's a 95 chim. Ran perfectly on the test drive
but on the way home,on the A1, it started to play up.
The engine died, but started ok and got me home
running very rough. The car seems ok until it's been
driven for a few miles then it coughs splutters and loses
power, also the tickover goes all over the place.
To say i was upset would be a gross understatement!!
It's a 95 chim. Ran perfectly on the test drive
but on the way home,on the A1, it started to play up.
The engine died, but started ok and got me home
running very rough. The car seems ok until it's been
driven for a few miles then it coughs splutters and loses
power, also the tickover goes all over the place.
To say i was upset would be a gross understatement!!
jr6yam said:
Picked up my fist TVR today, HOORAY
It's a 95 chim. Ran perfectly on the test drive
but on the way home,on the A1, it started to play up.
The engine died, but started ok and got me home
running very rough. The car seems ok until it's been
driven for a few miles then it coughs splutters and loses
power, also the tickover goes all over the place.
To say i was upset would be a gross understatement!!
Hopefully won't be too serious. Stick with it.It's a 95 chim. Ran perfectly on the test drive
but on the way home,on the A1, it started to play up.
The engine died, but started ok and got me home
running very rough. The car seems ok until it's been
driven for a few miles then it coughs splutters and loses
power, also the tickover goes all over the place.
To say i was upset would be a gross understatement!!
Recon thats prob just a dodgy connection. Can be a pain to find though. Hopefully you will get many people on here giving you pointers on where to look. Post up as much info on the symptoms as you can. Dont forget these are very simple engines. Most problems are due to the poor quality electrical connectors being cooked under the bonnet.
There pretty basic engines so i would guess its just a simple fault and not an accumulation of little problems resulting in a major problem if the test drive before the buy was quiet long, I would check the thingymagig next to the wotsitmecalled near the doo daa, then go for the oozit on the right hand side of the thingy near the eeerrrrr blobby, that should get you started, i'm sure with a bit more info we can get the big boys on the job and let me stop talking bo**x.



There's nothing worse than having all that excitement and expectation hosed down with a misbehaving engine. Two options here:
(1) start fiddling with this and that and replacing bits and pieces in the hope that you'll be lucky. Based on the lack of use and age, there's probably a bunch of faults or components operating out of spec that will make isolating the principal cause of the poor running, difficult and frustrating. Of course check the obvious things (HT leads, plug extender connections etc) but it could be something more than this lambda sensor(s), temperature sensor etc etc.
(2) get an experienced technician with a diagnostic facility to sort it out.
If you've just reached deep into your pocket to pay for the car/insurance etc then (2) might seem a daunting prospect and lead you to have a go at (1). However sequential replacements of this and that based on gut instinct, helpful advice and prayer can quickly mount up and delay the day you get in the car and begin to enjoy driving it.
My ten pennyworth - get a recommendation for a good indy in your area and get it sorted efficiently.
In the meantime give it a good polish/wax and get some color restorer and waterproofing protection on that roof
(1) start fiddling with this and that and replacing bits and pieces in the hope that you'll be lucky. Based on the lack of use and age, there's probably a bunch of faults or components operating out of spec that will make isolating the principal cause of the poor running, difficult and frustrating. Of course check the obvious things (HT leads, plug extender connections etc) but it could be something more than this lambda sensor(s), temperature sensor etc etc.
(2) get an experienced technician with a diagnostic facility to sort it out.
If you've just reached deep into your pocket to pay for the car/insurance etc then (2) might seem a daunting prospect and lead you to have a go at (1). However sequential replacements of this and that based on gut instinct, helpful advice and prayer can quickly mount up and delay the day you get in the car and begin to enjoy driving it.
My ten pennyworth - get a recommendation for a good indy in your area and get it sorted efficiently.
In the meantime give it a good polish/wax and get some color restorer and waterproofing protection on that roof
Chimjunkie said:
Recon thats prob just a dodgy connection. Can be a pain to find though. Hopefully you will get many people on here giving you pointers on where to look. Post up as much info on the symptoms as you can. Dont forget these are very simple engines. Most problems are due to the poor quality electrical connectors being cooked under the bonnet.
Cheers mate,i'm sure you're right.I won't be getting rid of my probe until it's sorted though!!
Welcome to tvr ownership!! I bought mine in November, and called the AA within 1 hour!!! Was a problem that was sorted by them so all was good. I bought mine knowing I would probably have some problems, little jobs to do, things to fix etc, I wasny wrong!
But if you treat it as a positive then you will be okay, I do. Its more fun to be under the bonnet and fixing things, getting to know the car. When it is running, and you take it out you will enjoy.
Hang in there, use the knowledge the boys and gals have on here,get it sorted, doesnt sound like a major problem you have, either fuel or electric, anything major you would not have got home!!
But if you treat it as a positive then you will be okay, I do. Its more fun to be under the bonnet and fixing things, getting to know the car. When it is running, and you take it out you will enjoy.
Hang in there, use the knowledge the boys and gals have on here,get it sorted, doesnt sound like a major problem you have, either fuel or electric, anything major you would not have got home!!
If it makes you feel any better, I was in a similar situation. It turned out to be a combination of things. The main one was that it had been serviced just before I bought it and the wrong rotor arm was fitted.
I took the car for a 250 mile drive today without a hickup. Stick with it. Its worth it
I took the car for a 250 mile drive today without a hickup. Stick with it. Its worth it

kenny Chim 4 said:
I agree with CJ.
Firstly, I would pop the bonnet and ensure that each spark plug shroud is firmly 'clicked' in place and then check for any visible damage to the HT leads.
Already done that! thought i'd cracked it when i foundFirstly, I would pop the bonnet and ensure that each spark plug shroud is firmly 'clicked' in place and then check for any visible damage to the HT leads.
the plug cap nmbr 8 was hanging off! But that wasn't it
John, I still think this is the area where your problem lies.
I mentioned checking the HT leads- further to that, I would perhaps replace those plug shrouds as they do deterioate under those temps. They are Vauxhall parts but the cheapest route is to order from Tim at ACT here:
http://www.actproducts.co.uk/
£5 cheaper than buying from Vauxhall. Call him for details.
I mentioned checking the HT leads- further to that, I would perhaps replace those plug shrouds as they do deterioate under those temps. They are Vauxhall parts but the cheapest route is to order from Tim at ACT here:
http://www.actproducts.co.uk/
£5 cheaper than buying from Vauxhall. Call him for details.
Don't panic yet, most intermitent rough idleing/running is down to the same old suspects which are easily changable items.
Could well be the poxy old stepper motor playing up ?? When the engine died what were you doing at the time ? Were you just pulling up to a roundabout or something i.e. lifting off the accelerater ?
Could well be the poxy old stepper motor playing up ?? When the engine died what were you doing at the time ? Were you just pulling up to a roundabout or something i.e. lifting off the accelerater ?
Thanx for all the hints guys
Today i cleaned the stepper motor (filthy)
and all the low tension connections. The dizzy cap
rotor arm look fairly new, but not lucas.
Made a few observations,took a couple of plugs
out 1 NGK and 1 was Bosch! The HT leads are
not great and didn't fit in the dizzy as per the
'bible' illustration?
The battery died overnight so i think i have
alarm 'issues' too. when i took the cover off i
found the main loom connection was very loose!
The ECU casing has lots of corrosion on it.
I jump started Christine! The engine ran for a few
minutes then died and wouldn't restart
Today i cleaned the stepper motor (filthy)
and all the low tension connections. The dizzy cap
rotor arm look fairly new, but not lucas.
Made a few observations,took a couple of plugs
out 1 NGK and 1 was Bosch! The HT leads are
not great and didn't fit in the dizzy as per the
'bible' illustration?
The battery died overnight so i think i have
alarm 'issues' too. when i took the cover off i
found the main loom connection was very loose!
The ECU casing has lots of corrosion on it.
I jump started Christine! The engine ran for a few
minutes then died and wouldn't restart
MoreSteam said:
If it makes you feel any better, I was in a similar situation. It turned out to be a combination of things. The main one was that it had been serviced just before I bought it and the wrong rotor arm was fitted.
I took the car for a 250 mile drive today without a hickup. Stick with it. Its worth it
jr6yam, the above post could be very relevant.I took the car for a 250 mile drive today without a hickup. Stick with it. Its worth it

I also had your symptoms and this is what it turned out to be - the rotor looked fine but it wasn't.
The guys at TVR Barnet know all about this and have some stocks. It really would be good for you to pick their brains - they are a great bunch.
Good luck.
jr6yam, the above post could be very relevant.
I also had your symptoms and this is what it turned out to be - the rotor looked fine but it wasn't.
The guys at TVR Barnet know all about this and have some stocks. It really would be good for you to pick their brains - they are a great bunch.
Good luck.
I'm not too far from barnet,so i might pop over tomorrow
I also had your symptoms and this is what it turned out to be - the rotor looked fine but it wasn't.
The guys at TVR Barnet know all about this and have some stocks. It really would be good for you to pick their brains - they are a great bunch.
Good luck.
I'm not too far from barnet,so i might pop over tomorrow
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


