help
Author
Discussion

reddybear

Original Poster:

79 posts

223 months

Sunday 1st February 2009
quotequote all
i was removing my battery today for a new one ,with no problems but when i tried to start the car the fuel pump did not prime ,i checked and the fuel pump fuse was blown so i replaced it thinking that would be it but it still would not prime,the alarm seems to be working fine and the engine is cranking over but i seem to have no fuel pump any thoughts would be appreciated

HRG

72,863 posts

270 months

Sunday 1st February 2009
quotequote all
Check the connectors in the NSR wheel arch. It could be that they are corroded and that's why the fuse popped.

ETA: Stick 12V directly on the pump to make sure it's still working ok.

Edited by HRG on Sunday 1st February 14:24

T_Pot

2,542 posts

228 months

Sunday 1st February 2009
quotequote all
mine did this same thing last week.

with mine, simply moving the wiring loom that hangs down fixed it, but have not yet had time to look further into sorting it

bjarkes

122 posts

215 months

Sunday 1st February 2009
quotequote all
"moving the wiring loom that hangs down" It does too in my car, its looks like a total mess, and seems to cause tvr owners a lot of problems. Can anyone tell me a good way to get this mess in order, without damaging the electric part and relays?

Bjarke

reddybear

Original Poster:

79 posts

223 months

Sunday 1st February 2009
quotequote all
i put a multimeter on the pump and there is no supply with ignition on and imobiliser disabled tried swapping relays and made no difference ,i am begining to think its to do with imobiliser when i changed the battery how can i reset it

HRG

72,863 posts

270 months

Sunday 1st February 2009
quotequote all
Ah, was it the fob battery you replaced not the vehicle battery? If so what happens with your other fob?

T_Pot

2,542 posts

228 months

Sunday 1st February 2009
quotequote all
reddybear said:
i put a multimeter on the pump and there is no supply with ignition on and imobiliser disabled tried swapping relays and made no difference ,i am begining to think its to do with imobiliser when i changed the battery how can i reset it
its not mate, its the loom by the battery, this stops the pump priming, move it about with the ignition on, and you will here the pump kick in

dickbastardly

450 posts

239 months

Sunday 1st February 2009
quotequote all
i had the same problem with mine last year!
it turned out to be the relay! i took it out cleaned it and put it back in and it worked!! this happened about 3 times and i thought i would replace the relay but it has not happened since! so i have left it!!
HTH
Andy