Dont waste that day off!
Discussion
Good luck... did the same thing myself this time last year.... very rewarding when you get it all done. What are you treating them with?
PS... I used a paint scraper to start with, the kind which has a point at one end and a half circle at the other, was just the right diameter for the tubing, and the pointy end was great for getting into the nooks and crannies...
PS... I used a paint scraper to start with, the kind which has a point at one end and a half circle at the other, was just the right diameter for the tubing, and the pointy end was great for getting into the nooks and crannies...
Edited by Red V8 on Monday 2nd February 12:33
Time for lunch, it's going well so far. Had a good dig with a screwdriver and a bash here and there and all seems solid so proceeded with paint scraper, wire brush and dremel.
I realise this is only a bit of general maintenance and you cannot get to all surfaces but I thought I had at least better have a good dig around to see how the chassis is doing.
I am going to use KBS rust seal and then a hefty dose of waxoyl.

Sorry can't get in today guv!


Wiped away some general gunk and waxoyl from main backbone, looks well protected.




Nothing nasty so far.
I realise this is only a bit of general maintenance and you cannot get to all surfaces but I thought I had at least better have a good dig around to see how the chassis is doing.
I am going to use KBS rust seal and then a hefty dose of waxoyl.

Sorry can't get in today guv!


Wiped away some general gunk and waxoyl from main backbone, looks well protected.




Nothing nasty so far.

Gassing Station | Chimaera | Top of Page | What's New | My Stuff





