Replacing hand brake cable
Replacing hand brake cable
Author
Discussion

scotty_d

Original Poster:

6,795 posts

225 months

Tuesday 3rd February 2009
quotequote all
I have a new hand brake cable to be fitted I have the old one out in the back end of the car no problem; I cannot see where it connects to the lever its self and where to gain access any ideas?

2 sMoKiN bArReLs

32,045 posts

266 months

Tuesday 3rd February 2009
quotequote all
yikes they have handbrakes?

scotty_d

Original Poster:

6,795 posts

225 months

Tuesday 3rd February 2009
quotequote all
2 sMoKiN bArReLs said:
yikes they have handbrakes?
laugh Apparently

paulathome

686 posts

249 months

Tuesday 3rd February 2009
quotequote all
IIRC you will need to take the zorst off to gain access to the bottom of the hand brake lever.
Quite straight forward once you can see, the cable is held to hand brake by a pin and clip.
Paul.

scotty_d

Original Poster:

6,795 posts

225 months

Tuesday 3rd February 2009
quotequote all
Never easy is itlaugh

S7Paul

2,103 posts

265 months

Tuesday 3rd February 2009
quotequote all
paulathome said:
IIRC you will need to take the zorst off to gain access to the bottom of the hand brake lever.
Quite straight forward once you can see, the cable is held to hand brake by a pin and clip.
Paul.
What he said. I also made the mistake of buying a new cable from a motor factors, not an OE one. The plastic end fittings which fit into the lugs on the calipers were too big and wouldn't fit, so I ended up buying the proper (and yes, more expensive) cable after all.

scotty_d

Original Poster:

6,795 posts

225 months

Tuesday 3rd February 2009
quotequote all
I bought mine from tvr power so should be good