Car Ramps
Author
Discussion

dorrick

Original Poster:

32 posts

221 months

Thursday 5th February 2009
quotequote all
I'm seriously considering buying a set of these ramps found on ebay

Before I do wondered if anyone on here had a set and are they suitable as the supplier cant advise if they are .

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&am...


wheels1

209 posts

219 months

Thursday 5th February 2009
quotequote all

spend

12,581 posts

282 months

Thursday 5th February 2009
quotequote all
I think I'll stick with my saw & a load of 8" x 2" at those prices hehe

Badmutha

658 posts

224 months

Thursday 5th February 2009
quotequote all
spend said:
I think I'll stick with my saw & a load of 8" x 2" at those prices hehe
idea I'll make these at 25 quid a set if anyone's interested

Badmutha Joinery Co
wink

Edited by Badmutha on Thursday 5th February 19:01

Barkychoc

7,848 posts

235 months

Thursday 5th February 2009
quotequote all
dorrick said:
I'm seriously considering buying a set of these ramps found on ebay

Before I do wondered if anyone on here had a set and are they suitable as the supplier cant advise if they are .

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&am...
How are you supposed to get under the side of the car with those - the ramp is in the way!

wheels1

209 posts

219 months

Friday 6th February 2009
quotequote all
Neil.
I should have said, I have a set of both the plastic ones, and the long metal ones and both are fine for a Chim.
The metal one's come primed not painted, so i hammerite mine and and fixed some ply to the slope with cable ties to make it smother to drive up. Both ramps are ok for quick jobs, such as oil change etc, but are not really high enough to spend loads of time working underneath for outriggers etc. For this i used them to lift the car off the ground and then it's much easier to jack the car up for axel stands, as Barkychoc says the long ones are hard to get at the side because they are, so long. I much prefer the plastic ones because they are so much easier to use as they are wider and shorter, so you can use them by yourself [ you don't need someone to watch you]. To be honest i would sell you my long metal ones if you want, as they don't really work for me. The problem is they came with half an acre of cardboard wrapping, which i no longer have, so it would be hard for me to post to you.

village idiot

3,226 posts

298 months

Friday 6th February 2009
quotequote all
i was thinking about this the other night... surely a pair of scaffolding boards with some beefy framing beneath would allow you to ramp the car up to a decent height using a relatively shallow angle?

spend

12,581 posts

282 months

Friday 6th February 2009
quotequote all
Segments of 8x2 all cut with a @20deg slope can be slotted / stacked together in as many ways as your imagination can invent. You can raise the front, back or all 4, and then remove sections to leave just the wheels supported. make them as hi/lo as you want wink I started off doing it so it was easy to get the jack underneath, and kind of just carried on adding to the collection. Nowadays I always stick the car up on them for just about anything - it saves all the bending down / over even doing interior / engine bay work hehe The only drawback is you need to plan where you want the car to be first of all, but you can jack /add support/lower if need be.