Engine cleaning??
Discussion
Personally I think its OK if you are careful with the application of the cleaner (paint brush or spray ),and use a paint brush to loosen the dirt. Then use an ordinary hose to wash it off, but avoid the connectors. Dont use these 1000 psi washers, the water ingress is appalling. Generally waters OK, but you dont want it to stay inside the connectors so its good to use an air line to blow water away, and dont garage the car until its all dry. A squirt of WD40 or the like afterwards wont do any harm either.
Mark
Mark
I'd go with GUNK. With a warm (NOT HOT!)engine, spray it onto everything. Leave it to work while you make a cup of tea. While you wait for the tea to cool use some thing like a 2" paint brush to work the gunk into the surfaces. Tea should be cool enough to slurp by now. Fill a watering can with hot water and use this to rinse off the gunk.
Start the engine to dry everything off. Finish off the tea and take the cup indoors. The engine will be dry and you will be able to see any bits you missed or that need another go.
When done take it out for a run to check for miss fires. If all's well then spray the HT leads with WD40. And thats it.
I'd avoid usinfg a pressure wash around the engine. A watering can or normal hose has always worked for me.
Start the engine to dry everything off. Finish off the tea and take the cup indoors. The engine will be dry and you will be able to see any bits you missed or that need another go.
When done take it out for a run to check for miss fires. If all's well then spray the HT leads with WD40. And thats it.
I'd avoid usinfg a pressure wash around the engine. A watering can or normal hose has always worked for me.
Edited by poorpeet on Saturday 7th February 11:56
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



