what is this wire?
Discussion
This yellow wire with the 2 blue cabelshoes comes from the airflowmeter (black wire) and goes through this little black box (very small) in the top right hand corner of the picture, and then join a couple of others wires and go down under the distribuater (second picture), What is it?






Edited by bjarkes on Saturday 7th February 15:17
The BW wire is the negative side of the ignition circuit. It connects over by the AFM then returns to the ECU to give it the engine speed input signal.
It also goes back into the "engine" loom (rather than ECU) to feed the tacho its pulses.
It also goes back into the "engine" loom (rather than ECU) to feed the tacho its pulses.
Edited by AntonyJ on Saturday 7th February 16:19
The small plug which the wire goes into is the Ignition amp attached to side of the distributor, I've just replaced mine as the old one broke down and stop working, lukily I had a spare to hand, mine is a pre-serp, but it looks like someone has had a wiring fault in the past and the cables shoes are the result of a repair
There is a single wire that runs between 2 of the looms.
Look at this, it might help, its produced from my V8S wiring.
If it doesn't display very well follow this http://tvrsseries.com/drawings/tvrv8wiring.jpg
Make the window full size and click on it to zoom to full size.

Look at this, it might help, its produced from my V8S wiring.
If it doesn't display very well follow this http://tvrsseries.com/drawings/tvrv8wiring.jpg
Make the window full size and click on it to zoom to full size.

Edited by Barkychoc on Monday 9th February 18:46
The ignition signal from the ignition module to the ECU goes via a dropping resister exactly like the one shown. Normally this runs along the nearside rocker cover and joins the loom before it passes through the bulkhead. I'm not sure from the picture whether that's what the wire is, but it looks like it.
Although this isn't electrically connected to the AFM in any way, it could be that somebody has decided to reroute it over there and then bundle it up with the loom from the ECU to the AFM.
Although this isn't electrically connected to the AFM in any way, it could be that somebody has decided to reroute it over there and then bundle it up with the loom from the ECU to the AFM.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


