Assembling rear callipers
Assembling rear callipers
Author
Discussion

scotty_d

Original Poster:

6,795 posts

225 months

Monday 9th February 2009
quotequote all
Having a few snags putting rear callipers back together I have the wind back tool for the job and have removed to the pistons and checked them and fitted new seals. Problem is they seem to get tight when wound about half way in and the bleed nipple is out so it’s not pressure any idea or is there a procedure for assembly for these?
(My father is doing the job as he is a mechanical engineer and now works hydraulics overhauling cylinders ect and doing it at his work, he has never came across callipers like this before. He has asked his boss who has been involved in the automotive industry for a number of years and is unsure also)

Help

Scotty
cry

GreenV8S

31,027 posts

315 months

Monday 9th February 2009
quotequote all
Did you reassemble the handbrake mechanism correctly? Unless it's all engaged I imagine it won't wind back in.

scotty_d

Original Poster:

6,795 posts

225 months

Monday 9th February 2009
quotequote all
I only removed the piston and seal did not touch the hand brake at all. Do you think this may be the problem?

GreenV8S

31,027 posts

315 months

Monday 9th February 2009
quotequote all
Have you seen how the handbrake mechanism screws into the piston? This is why you have to screw the piston back in. I suspect that it simply hasn't engaged properly.

scotty_d

Original Poster:

6,795 posts

225 months

Monday 9th February 2009
quotequote all
It is a very course thread only seem to catch the first 2-3 threads tops then its like it spins then goes tight

spend

12,581 posts

282 months

Monday 9th February 2009
quotequote all
Sounds like you freed the adjuster off, you need to wind it out then insert the piston. Its just reaching the end stop before the piston is fully home wink

scotty_d

Original Poster:

6,795 posts

225 months

Monday 9th February 2009
quotequote all
spend said:
Sounds like you freed the adjuster off, you need to wind it out then insert the piston. Its just reaching the end stop before the piston is fully home wink
Do you mean wind out the threaded bar?

spend

12,581 posts

282 months

Monday 9th February 2009
quotequote all
Can't remember TBH, IIRC I lubricated it, worked it in, then kept pulling the h'brake lever so it was fully out before inserting the piston. I kept doing it on the bench whilst I was working on the rest of the wishbones / uprights... just to make sure it was good & freed wink

Main thing is yank the lever till the thread doesn't turn anymore, don't insert the piston before that point. Then just wind the piston in, and wind it out operating the lever so its all nice & free..

scotty_d

Original Poster:

6,795 posts

225 months

Monday 9th February 2009
quotequote all
Cheers Spend, that is clear now just go and inform the old father and get him told

We had a deal I do his wiring on his boat and he overhauled my callipers and paints them he is mechanical I am electronics/electrical Engineer so its swings and roundabouts
laugh

Edited by scotty_d on Monday 9th February 23:02

scotty_d

Original Poster:

6,795 posts

225 months

Tuesday 10th February 2009
quotequote all
Still having snags with this just cant seem to get either of them to screw in when the seals are in place, when seals are out it screws in fine. its like the whole screwed bar is spining inside