idle speed
idle speed
Author
Discussion

chimalsu

Original Poster:

279 posts

269 months

Friday 13th February 2009
quotequote all
had the chim out for a run,and noticed the idle speed slow to return to normal.when reved or at junctions the revs drop to about 1200 and stay there for a few seconds then return to around 950-1000.the engine runs sweet no missfires just seems to rev high for a few seconds any one any ideas?

thegman

1,928 posts

235 months

Friday 13th February 2009
quotequote all
Could be a sticky stepper motor - there are lots of posts about this if you search

GreenV8S

31,027 posts

315 months

Friday 13th February 2009
quotequote all
That's the correct normal behaviour.

scotty_d

6,795 posts

225 months

Friday 13th February 2009
quotequote all
Mine is like that takes a few secs to return to idle. never really bothered me

chimalsu

Original Poster:

279 posts

269 months

Friday 13th February 2009
quotequote all
had the car for for years,30k,never done it before,cleaned the stepper,but i did put a thin fibre washer on the stepper to make a seal,il try with this removed.

GreenV8S

31,027 posts

315 months

Friday 13th February 2009
quotequote all
It was probably jamming before. smile

The intended behaviour is that it gives a fast idle until the vehicle has come to a halt. It takes a second or two for the revs to drop after it has come to a halt. (If the revs are hanging up for much longer than that the stepper is probably sticking open.)

blitzracing

6,422 posts

251 months

Friday 13th February 2009
quotequote all
chimalsu said:
had the car for for years,30k,never done it before,cleaned the stepper,but i did put a thin fibre washer on the stepper to make a seal,il try with this removed.
Putting a washer on the stepper will alter the point the control valve settles at. This should not normally be a problem on a new or spotless stepper, but it may now be moving on a dirtier part of the shaft under the spring casing the problem.