Front Indicator fitment
Front Indicator fitment
Author
Discussion

TimmyArt

Original Poster:

1,425 posts

249 months

Friday 13th February 2009
quotequote all
Ok, this has been covered and I'm sure I've read it but I couldn't find anything about it in the searches.

I've just bought clear indicator lenses and wondered if there is a thread on here showing the best way to fit them.
Any help would be most welcome with suggestions for sealent etc and best technique to remove and fit new.
Also fitting side repeaters

Thanks in advance

chimalsu

279 posts

269 months

Friday 13th February 2009
quotequote all
i just used black exterior silicone sealant,i know a lot of people on here use sicaflex(dont know if thats spelt right)and is probably better in the long term,but mine are sealed and secure.i removed the small grills and sealed the lenses in over night and then resealed the grills to the car by thraeding wire through the mesh and twisting over a piece of wood placed over the front of the car to apply pressure whilst the silicone cures.the side repeaters pull out if you slide them to one side,but be careful not to lose the wires inside the wing.i also put a bit of silicone on the backs when i replaced because the originals had a rubber backing and the new ones didnt.hope this helps.

TimmyArt

Original Poster:

1,425 posts

249 months

Tuesday 17th February 2009
quotequote all
Thanks Alan.
Does anyone know which Sikaflex to use - 291 or 221?? Is there a difference?
Any other tips peoples??

AlRaven

408 posts

240 months

Tuesday 17th February 2009
quotequote all
Timmy, what model year is it?

TimmyArt

Original Poster:

1,425 posts

249 months

Tuesday 17th February 2009
quotequote all
Year 2000, 450, covered headlight although dont think they changed any part of the indicators for that late update, just 96/97 I guess?

RumbleBee

333 posts

237 months

Tuesday 17th February 2009
quotequote all
Use Sikaflex 252, 251 or 521. Others will do, but not as sticky, nor are they self-priming like the ones opposite.

Meatball

1,638 posts

241 months

Tuesday 17th February 2009
quotequote all
I used super glue on mine boxedin

jonnylayze

1,640 posts

257 months

Wednesday 18th February 2009
quotequote all
Thanks guys. I'll give that a try in the next week or so.

TimmyArt

Original Poster:

1,425 posts

249 months

Monday 23rd February 2009
quotequote all
Job done. Quite a task pushing the old lenses out!!
I didn't use any glue to replace (they had orignally), just sealent front and back of the lenses, left over night then put more sealent over to finally seal - allowed to dry over night again and then screwed the bulbs/rear fixings in.. Thanks for the help chaps - looks really good.

Edited by TimmyArt on Monday 23 February 13:36