Discussion
Use the control to move the top of the mirror as far back (towards the front of the car) as possible. You should then be able to see through the gap at the bottom of the mirror a black tab. use a screwdriver to push the tab sideways which will release the mirror glass.
Its very obvious once you see it.
The mirror glass will have a black plastic fitting on the back. You need to remove that and fix it to the new glass. Make sure you use proper mirror pads (big one piece pad) not the small stick pads. I used the small pads and when the mirror heater had warmed up the glass fell out and did some damage to the paint on the door as it was hanging from its heater wires.
Its very obvious once you see it.
The mirror glass will have a black plastic fitting on the back. You need to remove that and fix it to the new glass. Make sure you use proper mirror pads (big one piece pad) not the small stick pads. I used the small pads and when the mirror heater had warmed up the glass fell out and did some damage to the paint on the door as it was hanging from its heater wires.
Edited by bigdods on Friday 13th February 20:34
bigdods said:
Use the control to move the top of the mirror as far back (towards the front of the car) as possible. You should then be able to see through the gap at the bottom of the mirror a black tab. use a screwdriver to push the tab sideways which will release the mirror glass.
Its very obvious once you see it.
The mirror glass will have a black plastic fitting on the back. You need to remove that and fix it to the new glass. Make sure you use proper mirror pads (big one piece pad) not the small stick pads. I used the small pads and when the mirror heater had warmed up the glass fell out and did some damage to the paint on the door as it was hanging from its heater wires.
Spot on with your info little clip not so clear most broke off.
Black plastic carrier was already attached to new glass.
New one pressed in and moved tab to lock job done.
Its very obvious once you see it.
The mirror glass will have a black plastic fitting on the back. You need to remove that and fix it to the new glass. Make sure you use proper mirror pads (big one piece pad) not the small stick pads. I used the small pads and when the mirror heater had warmed up the glass fell out and did some damage to the paint on the door as it was hanging from its heater wires.
Spot on with your info little clip not so clear most broke off.
Black plastic carrier was already attached to new glass.
New one pressed in and moved tab to lock job done.
Edited by bigdods on Friday 13th February 20:34
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



