Stalling????
Stalling????
Author
Discussion

Meatball

Original Poster:

1,638 posts

241 months

Sunday 15th February 2009
quotequote all
The car has now decided to stall almost every time i dip the clutch? the main culprit as i approach a junction dip the clutch to go into 1st or 2nd and it immediatly trys to stall?

Have cleaned the stepper (taking the spindle out)
Re set the ecu
Throttle pot was set about 6 months ago at .35 volts

Im hoping to borrow another stepper in the week to hopefully rule it out.

readIm sure i saw a post a little while back with someone who had the same problem?

AFM readings (if im using the correct wires)

blue/green
red

Ign on 0.57v
Engine running 2.0v





Edited by Meatball on Sunday 15th February 15:49

blitzracing

6,422 posts

251 months

Sunday 15th February 2009
quotequote all
The AFM reading is a bit high, its normally around 1.7 volts. More importantly make sure you have no air leaks around the plenum base or associated pipework, as its very sensitive to this at idle. Also make sure you allow the ECU to retrim the fuel mixture at idle after a reset. It takes about 20 seconds to do so, and must not be rev'ed during this period.

Meatball

Original Poster:

1,638 posts

241 months

Sunday 15th February 2009
quotequote all
Thanks blitz didnt know about not touching throttle after reset, will try again tommorow.