Exhaust doesnt fit back too good
Exhaust doesnt fit back too good
Author
Discussion

dbv8

Original Poster:

8,676 posts

251 months

Tuesday 17th February 2009
quotequote all
I have carried out a few winter jobs on my Chim and have removed the exhaust manifolds and y piece.
I decatted the manifolds, matched the ports a little, and wrapped the pre-cat parts to cut down on under bennet temps and help cut the tinny sounds that sometimes arise after losing the pre-cats.
The problem is that now ive replaced the manifolds, the y piece sits a good 1/4" away from 1 manifold. Is there a technique to 'squeezing' this gap shut before fitting the clamp or am i missing something?

spend

12,581 posts

282 months

Tuesday 17th February 2009
quotequote all
Put a 'tie down' strap round and then wind it up like an old fashioned tourniquet wink

This bending in position is a 'feature' of the clamped manifolds - a backward step from the good old flanged versions in the early cars IMHO.

dbv8

Original Poster:

8,676 posts

251 months

Tuesday 17th February 2009
quotequote all
Nice idea... will try that cheers.