Bleeding the Cooling system
Bleeding the Cooling system
Author
Discussion

debaron

Original Poster:

878 posts

228 months

Sunday 22nd February 2009
quotequote all


Changed my Manifold Temp Sensor yesterday but had the header tank lid off so quite a bit of water gurgled down into it from up in the block. I topped up the water through the Coolant Temp Sensor hole with a olive oil pourer (perfect for the job!) with header tank lid on this time - but fear I may have an airlock in the system - my water temp gauge zips from 70 up to 80 and then back down again, sometimes towards 50 in quick succession.

Popped the cap off the swirl pot (easier than I thought!!) and topped up to the brim but guess some still hiding somewhere!

How can I bleed the airlocks out or will they make their way out themselves?


Thanks



Ryan

bobfather

11,197 posts

286 months

Sunday 22nd February 2009
quotequote all
The only way to prime it is through the cap on top of the swirl pot. Top it off there and run the engine for a very short period. then recheck. Make sure you keep it cold. Repeat as required. Once the system is primed, i.e. no more water needed to top off the swirl pot, take the engine through a complete heat cycle. Once cold recheck the swirl pot level.

Important. The expansion pot must be no more than 1/3 full. Any more and it will eject hot water when the engine reaches running temperature


Edited by bobfather on Sunday 22 February 11:21

chrispitman

742 posts

285 months

Sunday 22nd February 2009
quotequote all
Also worth chacking on the top on one end of the rad there should be a small brass bleeding bolt, use this to get any air trapped in to top of the rad.

GreenV8S

31,027 posts

315 months

Sunday 22nd February 2009
quotequote all
After you've done the static fill and taken it through a heat cycle, you need to get out and drive it. The last few bubbles will hang around for ages but a bit of acceleration and cornering will help dislodge them. Check the levels again in a weeks time as you may find air pockets coming out for some time to come.

spend

12,581 posts

282 months

Sunday 22nd February 2009
quotequote all
Those blanked off pipes that served the throttle body 'de-icer' are useful for clearing air locks in that area. You can fill water through the lower one and bleed air through the upper one in the manifold.

Sticking the car nose up assists greatly when filling I find.

debaron

Original Poster:

878 posts

228 months

Sunday 22nd February 2009
quotequote all
Thanks guys much appreciated- will do that later this evening.