fast idle on 4.00??
fast idle on 4.00??
Author
Discussion

brisy72

Original Poster:

10 posts

213 months

Tuesday 24th February 2009
quotequote all
i cleaned the air filter as it was very dirty and put it back on now the engine idles at 1000-1100

i have driven the car for 20 mins but still idles at 1000-1100 is thiere something i can do to reduce the speed?

V8 Animal

6,015 posts

241 months

Tuesday 24th February 2009
quotequote all
On the plenum there is a allen bolt next to the vacuume pipe try turning it in a small amount.
Imperial key i think.
Sounds like your getting a better airflow now.

GreenV8S

31,027 posts

315 months

Tuesday 24th February 2009
quotequote all
Unlikely that the air filter has made any difference, more likely that you have dislodged a vacuum or breather hose. Have a very careful look all round the plenum and make sure all the hoses are intact and connected firmly at both ends. If you still can't find any problems, clean the stepper motor.

blitzracing

6,422 posts

251 months

Wednesday 25th February 2009
quotequote all
V8 Animal said:
On the plenum there is a allen bolt next to the vacuume pipe try turning it in a small amount.
Imperial key i think.
Sounds like your getting a better airflow now.
Go carefull on this one, its only a basic idle setting, and is set just high enough to stop the engine stalling (around 650 rpm) with the stepper motor feed blocked off and should not really need tweeking. The stepper should then keep it stable at say 800 rpm by letting in extra air as needed, so if the RPM is too high then as Green says check for an air leak first. I think the RPM can also be raised a bit if the ECU is in get you home mode if it finds a sensor out of range.

Mark

spend

12,581 posts

282 months

Wednesday 25th February 2009
quotequote all
Check the throttle cable is free & butterfly is closing first?

brisy72

Original Poster:

10 posts

213 months

Wednesday 25th February 2009
quotequote all
Thanks for the replys ,

i cleaned the stepper motor today, but its still going upto 1200rpm,


blitzracing

6,422 posts

251 months

Thursday 26th February 2009
quotequote all
You now enter the whole realm of how the ECU controls the idle mixture and idle speeds. You could try blocking (or clamping) the air feed pipe that leads to the stepper, and see how high it ticks over- it should drop to around 600 rpm. If its still over say 700 rpm its likely you have an air leak (assuming you have not been tweeting the base idle screw that is). If the tickover is slow and stable however, then we are most likely back to a faulty stepper motor. Cleaning the stepper is not just the cone area, you need to get behind the spring to clean the keyway shaft as well, as cabon builds up there.