ecu mapping adaption
ecu mapping adaption
Author
Discussion

stefan1200

Original Poster:

98 posts

268 months

Wednesday 25th February 2009
quotequote all
Hi all,

according to the bible the 14 cux starts to adapt the mapping to the engine when coolant temp reaches 90 deg.

Can anybody tell me whats happening to the fueling then? What could possibly happen without the adaption?

Reason for asking is the fitting of an alu rad with 74 stat and 80/75 otter switch, so under most conditions the coolant is not likely to reach 90 C.

Cheers,
Stefan

rev-erend

21,624 posts

315 months

Wednesday 25th February 2009
quotequote all
Funny - I thought only the GEMS system did adaptive mapping..

thegman

1,928 posts

235 months

Wednesday 25th February 2009
quotequote all
I thought it was less than 90? I thought it was designed to become adaptive after the engine had reached efficient operating temperature which would be more like 70. Mark Adams would be able to tell u

stefan1200

Original Poster:

98 posts

268 months

Wednesday 25th February 2009
quotequote all
The bible states cold start enrichment ends at 70 deg, whereas the mentioned adaption takes place at 90, which will normally only be reached in traffic with the standard otter switch temp rating somewhere above 90.

Don't know wether this adaption is really necessary, so far I didn't encounter any difference in engine running even on cold days with coolant never having reached 90 deg.


Stefan

GreenV8S

31,027 posts

315 months

Thursday 26th February 2009
quotequote all
As I understand it the adaption applies to the whole map and just adjusts it a bit to accomodate any small differences between the generic engine that it was designed for, and you specific engine. The closer the match is the less significant the adaption is and I suspect if you have a standard engine the adaption will be so small it won't make any difference. I remember Mark listing the conditions that had to be met before the adaptive values would be adjusted, I seem to remember it included the coolant temperature within limits, revs within limits, throttle within limits, lambdas within limits and all this being sustained for several tens of seconds. He also mentioned that some TVR engines would not actually capable of achieving all these conditions and would never have the adaptive settings updated.

Unless there's something funny going on with your engine I wouldn't think the adaptive setting is important.

stefan1200

Original Poster:

98 posts

268 months

Thursday 26th February 2009
quotequote all
Engine behaves normally in hot and cold condition, so everything seems to be fine even without adaption.

Many thanks to all for the input,
Stefan