Bonkers Coolant Temperature
Bonkers Coolant Temperature
Author
Discussion

debaron

Original Poster:

878 posts

228 months

Monday 2nd March 2009
quotequote all

Hi all,

My water temperature gauge is all over the place!

It will rise to 70 then drops right back down to 50 and then up again to 70/75 all within a couple seconds. Sometimes (when it's reading properly) it will sit at 80 - 85. I'm convinced that this erratic reading isn't actually the realtime temperature of my coolant so something must be amiss.


The Fans cut in now and again after the car has been running for a bit regardless of what's on the cockpit meter so the Otter switch seems to be doing it's job properly and the water is reaching 80 deg C (which has always been the temp at which my fans come on).

Heater blows hot too. It's not an Airlock as I've bled and re-bled the system and it's topped right up in the swirl pot now.


Can someone give me a run down on the coolant sensors (and possible test methods) which are responsible for the water temp gauge in the cockpit and which one talks to the ECU.

I recently changed the manifold water temp sensor and it started happening right after. Trouble is, went back to the old one and was still happening. Just want to make sure there isn't another temp sensor that could be giving me problems.



Cheers



Ryan



Chimjunkie

2,879 posts

242 months

Monday 2nd March 2009
quotequote all
That just sounds like a poor connection. Would go back to that recently changed sensor and disconnect/reconnect. Go for a spin and see what happens. An easy way to test is to take the sensor out and place in a cup of very hot water. If you keep it connected to the car you can then observe the behaviour of the system under controlled thermal conditions.

Meatball

1,638 posts

241 months

Monday 2nd March 2009
quotequote all
The ecu sensor is the one between the fuel rail and distributor (top corner of inlet manifold)
and dash gauge sensor is just below the alternator (sod to reach)

oops just read the post again and you already know that

Edited by Meatball on Monday 2nd March 22:05

debaron

Original Poster:

878 posts

228 months

Monday 2nd March 2009
quotequote all

Hi Meatball, do you mean the one in the bottom of the swirl pot? I though that was the Otter and not responsible for anything apart from the fans. I don't know of another apart from the one in the inlet manifold between fuel rail and dizzy as you say.

Is there another underneath the alternator? This could be the one probably causing my problems!!

Barkychoc

7,848 posts

235 months

Monday 2nd March 2009
quotequote all
The one under the alternator (ish) just has a single wire and is for the gauge.
The other one with a bigger connector is for the ECU.

Sorry not great pics all I could find, and scruffy too as these were before stripdown honest.
Note I don't think it makes a difference but these pics are of a pre serp V8S.







Edited by Barkychoc on Monday 2nd March 22:51

Meatball

1,638 posts

241 months

Monday 2nd March 2009
quotequote all
Barkychoc said:
The one under the alternator (ish) just has a single wire and is for the gauge.
The other one with a bigger connector is for the ECU.

Sorry not great pics all I could find, and scruffy too as these were before stripdown honest.
Note I don't think it makes a difference but these pics are of a pre serp V8S.







Edited by Barkychoc on Monday 2nd March 22:51
yes that looks like it, but i think on a serp set up its towards the bottom right of the alternator with a single push on lead.

spend

12,581 posts

282 months

Monday 2nd March 2009
quotequote all
I think there are 3 different manifolds, but all have the gauge sensor screwed into a big brass hex adapter wink

The sensor grounds to the block, over liberal application of plumbers aids can interfere with that. It also makes your testing in a cup a bit tricky Jon hehe

Chimjunkie

2,879 posts

242 months

Monday 2nd March 2009
quotequote all
spend said:
The sensor grounds to the block, over liberal application of plumbers aids can interfere with that. It also makes your testing in a cup a bit tricky Jon hehe
hehe Only needs a wee earth strap rolleyes

debaron

Original Poster:

878 posts

228 months

Monday 2nd March 2009
quotequote all

Thanks guys - excellent info. Thanks to Barkychoc for the great photos too!

Ryan