Measurement Please

[Rusti Evo]

Is it possible somebody could measure the distance from the face of the adaptor plate to the bulkhead please?

Preferably with G50-52.

[60mph]

Not quite sure what you mean but I've taken the following;

From rear aluminium bulkhead surface horizontaly to rear surface of block to which the adaptor plate bolts on to = 773 mm.Measured at the joint between block and cylinder head as engine may not be in frame exactly horizontal.This is taken from my SBC finished GTR.
Frank

[Steve_D]

Don't forget the bulkhead is vertical to the first chassis rail then angles back into the engine bay. If you are trying to understand if a particular engine will fit then you need that info as well.

Steve

[Rusti Evo]

Steve_D said:

Don't forget the bulkhead is vertical to the first chassis rail then angles back into the engine bay. If you are trying to understand if a particular engine will fit then you need that info as well.

Steve

Thanks for that Steve.

Has any one ever made any drawings of the engine bay?