It's Friday the 13th.
It's Friday the 13th.
Author
Discussion

wheels1

Original Poster:

209 posts

219 months

Friday 13th March 2009
quotequote all
MOT time today, check the wipers, the horn, the indicators, the fog light, the reversing light the brake lights and all where ok. Drove to the MOT station 1/2 a mile away [ might even be a 1/4 of a mile].
He checked the the wipers, the horn, the indicators, the fog light, the reversing light and bugger where have the brake lights gone. I know what my job for tomorrow will be ! Bugger.

MoreSteam

698 posts

221 months

Friday 13th March 2009
quotequote all
Have you been driving it regularly? I've had the pedel switch giving a poor connection. Seems to happen most when left for a while, which makes sence. I just removed the switch unit and sprayed contact cleaner into it. I worked the switch a couple of dozen times and gave it a good soaking in WD40 before refitting.

CLN1

657 posts

256 months

Friday 13th March 2009
quotequote all
It's usally the connector block in the loom behind the carpet on the nearside on mine.

Colin.

wheels1

Original Poster:

209 posts

219 months

Friday 13th March 2009
quotequote all
Thanks for the advise guy's.
Colin, could you be more specific re the location of the connector? All i did between checking and the mot station was put the roof in the boot and replace the pass. side foot well carpet over the battery.
Thanks
Grant

CLN1

657 posts

256 months

Friday 13th March 2009
quotequote all
Grant

On the nearside of the car there's a carpet clad flap which you can lift up to reveal the loom, just below the top seatbelt fixing.

Colin.

wheels1

Original Poster:

209 posts

219 months

Saturday 14th March 2009
quotequote all
Ok
got up this morning bright and early, went to check, and they worked fine. went for a spin got back and they worked fine, pumped the pedal 6 times and they went out? Thought it must be the switch so got the WD out and bob's your Uncle all back and working, i will just have to keep an eye on it for a while.
Colin i had a look for the bit you meant, all i could find was a cubby hole with a Velcro covering behind the pass. seat, but no access to wiring no unless i ripped the carpet off as it was glued.
Mine's a 99 chim so it may be different?
thanks for the advice

Grant

CLN1

657 posts

256 months

Saturday 14th March 2009
quotequote all
Yeh, perhaps different. My Griff's a 98 although I thought that they were all the same.

Colin

WOO5IE

967 posts

228 months

Saturday 14th March 2009
quotequote all
Grant

The flap is behind both of the door pillars either side . you can get to the door locking mechanism as well as some of the loom,

Trev