Electrical Question - ECU/Manifold Coolant temp sensor
Electrical Question - ECU/Manifold Coolant temp sensor
Author
Discussion

debaron

Original Poster:

878 posts

228 months

Sunday 15th March 2009
quotequote all

Just a quick one to ask if anyone knows what the resistance should be across the two terminals of the manifold coolant temperature sensor. I think I may have an intermittent/dodgy connection to ECU that could be causing my intermittent rough running.

Cheers

Ryan

Meatball

1,638 posts

241 months

Sunday 15th March 2009
quotequote all
Ryan do you know the part number for a new sensor? as im going to replace mine

spend

12,581 posts

282 months

Monday 16th March 2009
quotequote all
Google around SNB802 I think thats the ECU temp sensor, if not its certainly on either the Chim or Griff parts lists.

GreenV8S

31,027 posts

315 months

Monday 16th March 2009
quotequote all
debaron said:
Just a quick one to ask if anyone knows what the resistance should be across the two terminals of the manifold coolant temperature sensor. I think I may have an intermittent/dodgy connection to ECU that could be causing my intermittent rough running.

Cheers

Ryan
It should be roughly 5kOhm at 0C and roughly halving per 20C increase.

debaron

Original Poster:

878 posts

228 months

Monday 16th March 2009
quotequote all

Thanks GreenV8S - I was actually after the measurement of the circuit to ECU and back - Not the reading off of the Temp Sensor itself, although It's handy to know the expected o/p of the sensor. I can double check to make sure that the sensor itself is all good - even though it is a brand new.


debaron

Original Poster:

878 posts

228 months

Monday 16th March 2009
quotequote all

Also, to confirm Spend is correct with that part number. SNB802

I got mine from Simpson Supplies somewhere in Scotland. Hasn't cured my problem but then I'm not sure that it was the problem in the first place!


https://www.simpsonsupplies.co.uk/ENGINE_MANAGEMEN...

Meatball

1,638 posts

241 months

Monday 16th March 2009
quotequote all
debaron said:
Also, to confirm Spend is correct with that part number. SNB802
Thanks chaps

spend

12,581 posts

282 months

Monday 16th March 2009
quotequote all
Its a common part across Jags, other Rovers.. etc. as well IIRC, so should be available from a variety of sources wink

blitzracing

6,422 posts

251 months

Monday 16th March 2009
quotequote all
debaron said:
Thanks GreenV8S - I was actually after the measurement of the circuit to ECU and back - Not the reading off of the Temp Sensor itself, although It's handy to know the expected o/p of the sensor. I can double check to make sure that the sensor itself is all good - even though it is a brand new.
Disconnect the sensor, and then measure the voltage across the connector from the loom. You should have 5 volts it with the ignition on, nothing more to it than that.

Mark