Wheel & Suspension settings
Discussion
Hi all, I've recently put Gaz Gold Pro shocks on my chim, very pleased with them but i now want to make sure that the rest of the car is set up properly, so does anyone know the correct camber, toe and caster settings for a chim? There is a garage local to me with laser alignment and i would like to give him the best settings to work to.
Many thanks for any help
Lee
Many thanks for any help
Lee
K4TRV said:
From an earlier discussion from Ab shocks:
Decrease toe in and increase camber on the front for trackday stars.
Front
Camber = 0.5 to 0.75 degrees Neg
Toe = 1.5mm overall toe or 12 minutes
Rear
Camber = 1.3 degrees Neg
Toe = 3mm overall toe in or 24 minutes
Trev
Thats great, thanks Trev!Decrease toe in and increase camber on the front for trackday stars.
Front
Camber = 0.5 to 0.75 degrees Neg
Toe = 1.5mm overall toe or 12 minutes
Rear
Camber = 1.3 degrees Neg
Toe = 3mm overall toe in or 24 minutes
Trev
schmokin1 said:
snippity........ do I divide by two to set each wheel? ie a 1.5mm toe would be 0.75 per wheel adding to 1.5 total toe in?...snip
Sounds correct to me - however, comma, you need to ensure you know when the wheel is parallel to the centre line of the car before you set 0.75mm. Not to the body-work or other reference points that are not necessarily aligned !!
That is the hard bit !!
Regards.
Trev
schmokin1 said:
trev, those toe figures, do I divide by two to set each wheel? ie a 1.5mm toe would be 0.75 per wheel adding to 1.5 total toe in?
cheers
schmo (i'm going to get the fishing line out, do a chassis drop test and check my geo before getting mine going for the summer)
Yep, divide total by 2 for wheel toe.cheers
schmo (i'm going to get the fishing line out, do a chassis drop test and check my geo before getting mine going for the summer)
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


