Unusual non-start problem
Unusual non-start problem
Author
Discussion

WokingWedger

Original Poster:

1,030 posts

236 months

Tuesday 17th March 2009
quotequote all
Happened three times now.

After a good run (read engine nice an hot, I get home and need to go out again and the car wont start. Turns over fine (nice and fast), but wont fire.

There is a spark from the king lead and at least 2 plugs (didnt check them all as its bl**dy hot around them). Checked by plugging in an old timing strobe.

I beleive fuel is readily available as there was a very strong smell, and so was probably then flooded.
I tried lots of things first and second time it happened including disconecting ECU.

It started after several hours after just leaving it.

Second time I took it to a well repected TVR specialist and he said the fault code showed an Oxygen sensor problem ( not sure how this showed after I pulled the ECU plug though). He found a bad connetion to the sensor and 'fixed it'.

This time would not start after an hour, and I had to push it into the garage.

How long do you have to wait if you have flooded the engine.

Am I some how causing the engine to flood when starting it, (when hot starting should I use throttle when cranking)

Is using a strobe light any good as an indication of a 'good' spark.

What else can I check tonight when I get home ?

Mind you if it starts, I cant check anything.

I havent touched the ECU plug this time, so I could get some one to put a reader on it I suppose.

Any thoughts any one ?

Please

mdotrutherford

384 posts

288 months

Tuesday 17th March 2009
quotequote all
I had similar symptons and it turned out to be the coil.
Only other thought I have is the immobiliser has an intermittent fault.
HTH

WokingWedger

Original Poster:

1,030 posts

236 months

Tuesday 17th March 2009
quotequote all
I thought of the coil, but I appear to be getting a spark (or at least it lights the Strobe gun)

If it was the imobiliser, wouldnt that cut power to the starter motor though ?

WokingWedger

Original Poster:

1,030 posts

236 months

Tuesday 17th March 2009
quotequote all
How do I check the coil? Will removing a plug and laying on the block tell me anymore than seeing the strobe gun fire ?

spend

12,581 posts

282 months

Tuesday 17th March 2009
quotequote all
Get the injectors checked?

WokingWedger

Original Poster:

1,030 posts

236 months

Tuesday 17th March 2009
quotequote all
spend said:
Get the injectors checked?
I did wonder about the injectors, but it was running fine until I turned it of and tried to start it again a bit later. Why would the injectors do this ?

spend

12,581 posts

282 months

Tuesday 17th March 2009
quotequote all
One might be incontinent hehe

WokingWedger

Original Poster:

1,030 posts

236 months

Tuesday 17th March 2009
quotequote all
Are you saying one could be leaking and filling /flooding one cylinder ?

I suppose its possible but would that stop it actually starting, may misfire until its burnt off, bu to not fire at all ?

spend

12,581 posts

282 months

Tuesday 17th March 2009
quotequote all
If it pools in the inlet manifold it will adversely affect several pots wink even a slight constant dribble could pool quite quickly..

Iffy injectors have been known to run fine at chat, but have caused endemic problems with starting and low throttle running AFIK. Not arguing that that is your problem, just one possibility wink If you have sparks and petrol you need to start looking why it isn't going bang! and the EFis are buggers once they flood... sure we all have different ways of fixing it, never had it on the TVR but plenty of LR's over the years but its normally when cold.. hot is unusual and normally electrical ?


bsdnazz

762 posts

284 months

Tuesday 17th March 2009
quotequote all
spend said:
(snip)
EFis are buggers once they flood... sure we all have different ways of fixing it, never had it on the TVR
(snip)
I've flooded my 400 Chim quite a number of times. Usually when reversing in our out of our parking spot. The last time was on Feb 3, the day after the big snow and it was cold.

I've found that the best way to get a flooded engine to restart is to start the engine on full throttle to allow as much air to pass through the engine and possible and take the extra fuel out. It does pay to make sure your battery is good though!

debaron

878 posts

228 months

Tuesday 17th March 2009
quotequote all

Definitely check if you have a spark at the plugs. My ignition amplifier went the other day when hot and wouldn't start. Checked the plugs - nothing...change back to old amp and bingo...

WokingWedger

Original Poster:

1,030 posts

236 months

Wednesday 18th March 2009
quotequote all
Got home from work last night and she started. (car not wife ! )

It was misfiring badly but it did start.

I Cleaned the rotor arm up ( very slight corossion pitting)and took all the plugs out and cleaned them up and re gapped them (they were very slightly to wide and very wet and sooty)

Couldnt try firing her up again as it was now midnight.

Could it be just me using the wrong hot start technique and flooding it ?

After a bad flooding would the ECU record something (like the oxgen sensor trying to compensate)and give a fault codelike the garage mentioned last time it happened ?
I have now ordered new plugs, shrouds and coil to be on the safe side.

Edited by WokingWedger on Wednesday 18th March 10:59

spend

12,581 posts

282 months

Wednesday 18th March 2009
quotequote all
bsdnazz said:
spend said:
(snip)
EFis are buggers once they flood... sure we all have different ways of fixing it, never had it on the TVR
(snip)
I've flooded my 400 Chim quite a number of times. Usually when reversing in our out of our parking spot. The last time was on Feb 3, the day after the big snow and it was cold.

I've found that the best way to get a flooded engine to restart is to start the engine on full throttle to allow as much air to pass through the engine and possible and take the extra fuel out. It does pay to make sure your battery is good though!
That is my first quick attempt, if it doesn't work charge the battery for max oomph, pull the fuel fuse and fire it up with no gas. Patience is the key it is easy to keep trying when it burps a bit and just make the situation worse hehe

WW, I would have tried ign amp first ~ that seems to be the classic intermittent failure... I would always advise keeping a spare that you know works, it just saves so much time diagnosing... wink