Clutchless driving advice.
Discussion
I need to replace the clutch slave cylinder so I can get the Chim on the road again. I tried a few weeks ago, but my jacking looked unsafe and I bottled out. I don't have anywhere flat and off the road to jack the car up high enough.
I think the best option is to take it to my local garage, it should only be a 5 minute job for him. I'll take it down late at night, so I can see if cars are approaching junctions by their headlights. I have three T junctions and two right turns to make (only about a mile away).
What is the best way to do this? Keep in first or second? If I need to stop should I use the key or stall using the brakes?
Never tried this before, so any advice on what to expect would be helpful.
I think the best option is to take it to my local garage, it should only be a 5 minute job for him. I'll take it down late at night, so I can see if cars are approaching junctions by their headlights. I have three T junctions and two right turns to make (only about a mile away).
What is the best way to do this? Keep in first or second? If I need to stop should I use the key or stall using the brakes?
Never tried this before, so any advice on what to expect would be helpful.
May I suggest that you dont drive under any circumstances! If you are unfortunate to have an accident you will not be covered by your insurance. Ok if you hurt yourself or your car, your choice, but if you hurt somebody else........either get the AA or somebody else to tow you. Just my opinion...

Blimey whats wrong with you all?
I drove my Griff 30 miles without a clutch to get it repaired.
With a bit of planning and some very gentle gear changes its not THAT difficult with the torque these engines have got.
Plan your route to avoid traffic/pedestrian lights and so you have as few right turns as possible, because right turns mean you are most likely to have to stop, whereas left turns can be approached steadily and driven straight around if visibility is good.
Have a play in your daily drive, clutchless driving is possible in pretty much anything, you just need to know how to blip the throttle to take the stress out of getting out of gears.
I drove my Griff 30 miles without a clutch to get it repaired.
With a bit of planning and some very gentle gear changes its not THAT difficult with the torque these engines have got.
Plan your route to avoid traffic/pedestrian lights and so you have as few right turns as possible, because right turns mean you are most likely to have to stop, whereas left turns can be approached steadily and driven straight around if visibility is good.
Have a play in your daily drive, clutchless driving is possible in pretty much anything, you just need to know how to blip the throttle to take the stress out of getting out of gears.
Barreti said:
Blimey whats wrong with you all?
I drove my Griff 30 miles without a clutch to get it repaired.
With a bit of planning and some very gentle gear changes its not THAT difficult with the torque these engines have got.
Plan your route to avoid traffic/pedestrian lights and so you have as few right turns as possible, because right turns mean you are most likely to have to stop, whereas left turns can be approached steadily and driven straight around if visibility is good.
Have a play in your daily drive, clutchless driving is possible in pretty much anything, you just need to know how to blip the throttle to take the stress out of getting out of gears.
Ford RWD boxes are the nuts for this kind of thing Barreti I drove my Griff 30 miles without a clutch to get it repaired.
With a bit of planning and some very gentle gear changes its not THAT difficult with the torque these engines have got.
Plan your route to avoid traffic/pedestrian lights and so you have as few right turns as possible, because right turns mean you are most likely to have to stop, whereas left turns can be approached steadily and driven straight around if visibility is good.
Have a play in your daily drive, clutchless driving is possible in pretty much anything, you just need to know how to blip the throttle to take the stress out of getting out of gears.
but in saying this i would go with Bluejay on this one,the roads have enough dangers without adding to em,if someone ran into your car doing the above you would do ya b
ks,i know i would
trailer it or fix it where you are.Edited by That Daddy on Tuesday 17th March 20:38
If it's only a mile, can you get the whole way in 1st gear and avoid the whole clutchless gear change thing completely? Because it's definitely possible to do, but the less skilled you are the more damage it will do to the 'box and it's definitely not something you want to do to a car you care about except as a last resort. If you do go for it, make sure the engine is hot before you set off to make it as easy as possible to start up in gear. If you do find yourself coming up to a queue, you can hold it down to about 500 rpm in 1st (roughly walking speed) by holding it back on the brakes, that's very preferable to stopping and restarting. If you absolutely need to stop, switch off to avoid bouncing the engine off the transmission.
These engines are very hard to stall using the brakes, especially when cold. My master cylinder went when I was reversing, couldnt stall the engine with the brakes, had to accelerate backwards to balance revs and snick out of gear. Very very scary.
BTW if you order a new master cylinder, to the correct part number, it doesnt fit, turns out TVR tapped them out to (11/16"? Possibly but could be wrong), which is what I ended up doing. Plus, helps if you have a teenage girl to hand (small hands, to get the bolts done up, shame on you if you were thinking anything else).
BTW if you order a new master cylinder, to the correct part number, it doesnt fit, turns out TVR tapped them out to (11/16"? Possibly but could be wrong), which is what I ended up doing. Plus, helps if you have a teenage girl to hand (small hands, to get the bolts done up, shame on you if you were thinking anything else).
I just had the master go on mine a couple of weeks ago i was about 8 miles from home and i managed just to get it home stuck in 4th gear i had to go through 6 sets of lights and at least 6 roundabouts i would not reccomend it i was very lucky . I am like you and live about a mile from a friends garage but i am in Britannia road rescue and i got them to trailer it the mile to the garage cost was zero and also no danger and zero stress .
Thanks for the suggestions. One thing I should have added is I'm in a rural location. 99.9% of the time you never see another car after midnight. 70% of the route has no junctions or houses.
I'm in the AA, but don't have home start, so would have to roll the car a quarter of a mile down the road and that does away with two of the worst junctions. I will probably drive it down a 1am though, to save the hassle.
Just had a brain wave
, I'll try the local mobile mechanic.
I'm in the AA, but don't have home start, so would have to roll the car a quarter of a mile down the road and that does away with two of the worst junctions. I will probably drive it down a 1am though, to save the hassle.
Just had a brain wave
, I'll try the local mobile mechanic. drew.h said:
Thanks for the suggestions. One thing I should have added is I'm in a rural location. 99.9% of the time you never see another car after midnight. 70% of the route has no junctions or houses.
I'm in the AA, but don't have home start, so would have to roll the car a quarter of a mile down the road and that does away with two of the worst junctions. I will probably drive it down a 1am though, to save the hassle.
Just had a brain wave
, I'll try the local mobile mechanic.
I'm in the AA, but don't have home start, so would have to roll the car a quarter of a mile down the road and that does away with two of the worst junctions. I will probably drive it down a 1am though, to save the hassle.
Just had a brain wave
, I'll try the local mobile mechanic.
good idea,a mobile mechanic should be able to do this job with his eyes shut
although its leaking you may well be able to bleed the one on the car just to get you to a garage,its not often its leaking so bad that you are not able to do this for a short period 
It leaked first before Christmas, local garage flushed it and couldn't find any leak. It worked while Track V Road had it for the engine work and up until the new year. I tried adding fluid and pumping the peddle, but just get a puddle of fluid on the road.
Dads suggestion was to try something thicker, such as fairy liquid, which he has done before (he is an old retired mechanic). Not knowing how clutch fluid and modern washing up liquid would react, I was unwilling to try it.
Dads suggestion was to try something thicker, such as fairy liquid, which he has done before (he is an old retired mechanic). Not knowing how clutch fluid and modern washing up liquid would react, I was unwilling to try it.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff





