PAS Leak - Advice Required
PAS Leak - Advice Required
Author
Discussion

Clippy

Original Poster:

196 posts

214 months

Thursday 19th March 2009
quotequote all
I've just spotted a pool of 'oil' under the front offside corner of the car (95 Chim 400HC).

Jacked it up and it's PAS fluid, and it's sprayed liberally all over everything underneath (mixed into nice patterns with the Mobil 1 that's seeping from the back of the sump?!?!).

Started getting annoyed as it had a recon rack fitted in November and couldn't believe that this could have given up already...

Long and short of it is that the rubber hose that goes into the top union on the rack has been just touching the big central exhaust pipe, the down pipe from the y-piece, when on full lock and has melted a small hole in the hose.

Is this a TVR specific part and is it an easy job to replace and recharge the PAS system, or am I going to have to 'squirt' my way to a garage?!

Could I splice in a repair with some tubing? Does anyone know the internal diameter of the PAS hose?

Cheers

Giles

PS. Off to shower in brake fluid now just to complete the full 'lubricated' look!
PPS. Tightened the sump bolts while I was under there - will re-seal sump once I have sorted the PAS!

Edited by Clippy on Thursday 19th March 14:12

Clippy

Original Poster:

196 posts

214 months

Thursday 19th March 2009
quotequote all
OK - may have answered my own question... idea

Assume that as hose has jubilee rather than pressure fitting that it is the return hose to the reservoir and, on that basis could be spliced or patched short-term to keep the car OTR while I get a replacement hose?

G

PS. Brake fluid shower appears to have removed most dirt and some skin...is this what they use for 'chemical peels' at spa hotels?! scratchchin

spend

12,581 posts

282 months

Thursday 19th March 2009
quotequote all
Its definitely far better than WD40 / penetrating oil for freeing seized bds IMHO hehe

Bet Terry Waite wished I'd given him the tip rofl

STE VR

501 posts

237 months

Thursday 19th March 2009
quotequote all
If it's got the jubilee clip then it's just a case of replacing said length with appropriate type piping. Not worth repairing and not too bad of a job. When refilling the system I just turned steering fully left and right(engine running) until all air was gone and just topped up reservoir accordingly. You will know when all air is expelled when the the steering goes quiet.

bjarkes

122 posts

215 months

Thursday 19th March 2009
quotequote all
What olie is correct for the PAS?

STE VR

501 posts

237 months

Thursday 19th March 2009
quotequote all
I have always used ATF 220 in mine as per the factory recommendations.

sbrind4734

39 posts

251 months

Thursday 19th March 2009
quotequote all
Hi Clippy,

I've got same year and model Chim as yours , mine leaks. I had all of my sterring rack rebuilt on the last but one service,my garage managed to stem most of the leaks but.........still have to top up ever now and again.

chrispitman

742 posts

285 months

Thursday 19th March 2009
quotequote all
Got my hose from www.pirtek.co.uk invoice shows

100R6-08 2Meter
100R6-10 1Meter

Cost about £20, this was enough to replace all the pas pipes which use the jubelee clips.

Clippy

Original Poster:

196 posts

214 months

Thursday 19th March 2009
quotequote all
Cheers everyone!

I've ordered a new hose from the TVR Shop and, so I can use the car over the weekend until it arrives, I've 'bandaged' the section with the pin-hole with another section of hose, plenty of contact adhesive and some jubilee clips...

Tomorrow I might even dare to start it up and see whether or not it still leaks!

Now for a quick pint of Castrol TQF and bed!