Set of 17" alloys but not sure if they are suitable??
Set of 17" alloys but not sure if they are suitable??
Author
Discussion

Golflion

Original Poster:

2,782 posts

252 months

Thursday 19th March 2009
quotequote all
Chance of buying 4No 17" alloys with tyres which came off a TVR but not sure which?

The offset is 40. This is not correct for a tvr, so the guy had spacers on with longer wheels studs. these will be supplied with the wheels. and the wheel nuts. as they are special nuts to fit the wheels.
PCD is a ford size 108 so he says they may fit other cars?

Tyre sizes are
front 205/40/17
rear 225/45/17

Can anyone tell me if these will fit a Chim 96 or should i forget about them????

scotty_d

6,795 posts

225 months

Thursday 19th March 2009
quotequote all
The pcd is right and tyre size is fine but not sure about offset.

Edited by scotty_d on Thursday 19th March 19:55

daz the plumber

14,997 posts

262 months

Thursday 19th March 2009
quotequote all
what is the j , you need 7.5 .think you would get away with it with a 10 or 15mm spacer on the front .i just got a full set of pro race 1.2 with tyres £700.made to measure

Golflion

Original Poster:

2,782 posts

252 months

Friday 20th March 2009
quotequote all
Been told 7.5 on front and 8.5 on rear?

daz the plumber

14,997 posts

262 months

Friday 20th March 2009
quotequote all
sounds good to me .!

rigga

8,808 posts

232 months

Friday 20th March 2009
quotequote all
Spacers are a bodge...... imho

daz the plumber

14,997 posts

262 months

Friday 20th March 2009
quotequote all
can`t see a problem with spacers, get the expensive ones not the multi fit from halfords .

Golflion

Original Poster:

2,782 posts

252 months

Saturday 21st March 2009
quotequote all
aaaaahhhhhh,not so sure now was going to buy...is it a bit of a bodge or is spacing well used...help quick!!confused

Chimjunkie

2,879 posts

242 months

Saturday 21st March 2009
quotequote all
a lot of torque going through non standard, lengthened wheels studs. Not for me.

Uncle Fester

3,114 posts

239 months

Saturday 21st March 2009
quotequote all
I looked hard at the choices.

There is no point in fitting a wheel that is bigger than necessary to fit the best tyre available. To do so is just unnecessary metal and unsprung weight.

Remember, the choice must fit under the wheel arch, be a suitable speed rating and be a tyre that suits the weight of your car. The profile must give a diameter close to the original.

To achieve this, you consult the availability charts for 17” tyres; you will find you need a 40 profile. Not all the widths that give a suitable diameter are available. This limits your choices.

The best available is (IMHO) 225/40 R17 front. This only needs a 7J front. The back needs a 245/40 R17 which can be done on an 8J. You could go a bit bigger and fit to an 8.5J with a 255/40. But a lot of wheels are only 8 or 9J not half sizes.

daz the plumber

14,997 posts

262 months

Sunday 22nd March 2009
quotequote all
best sizes for a front and rear 17" wheels are


front 215/40/17 7 or 7.5j

rear 245/40/17 8 to 9j
3mm smaller than the standard
standard tyre sizes.
front 205/55/15 7j to 7.5

rear 225/50/16 7.5 to 8j