Get rid of Induction Pipe
Get rid of Induction Pipe
Author
Discussion

debaron

Original Poster:

878 posts

228 months

Saturday 21st March 2009
quotequote all

I was thinking:

'why can't I just do away with the induction pipe altogether'

It's rough and restrictive to the airflow not to mention ugly. What would be wrong with just sticking an Air Filter of some kind over the AFM and taking my air from there?

Ok the under bonnet temps would mean any air entering would be a little less dense and therefore less power would occur but you gain a great deal by getting rid of the pipe in the first place?

Does anyone know what kind of numbers we are talking about here - air temp increase VS air restriction?


I might try it tomorrow just to see!

spend

12,581 posts

282 months

Saturday 21st March 2009
quotequote all
You really need to shield it, and try to get the existing pipe to feed some cold air - but then you need to work out how to shroud the front... The engine bay can be pretty stagnant, IMHO the bonnet vents do very little except allow convecting air to escape at a standstill.

A filter directly on to the AFM is not great, you need a smooth flow hitting the AFM. Think of the Filter, the AFM, the bend.. like an outcrop of rocks in a stream, the best you can do is get nice flow on entry to them. If they are bunched too close together its like a load of rapids IYSWIM. TBH I would only seriously consider that type of mod worth the effort of insulation and 'airbox' when the AFM is dispatched with wink