Rear Wheel Bearing Torque ??????

[Jim Green]

Just changing a rear wheel bearing assembly (Tuscan Speed 6)........... Anyone know the torque on the main nut........????

Edited by Jim Green on Monday 23 March 15:09

[rev-erend]

Answer probably here ..

http://www.varleyhyd.com/FJ062.asp#Fault%20codes

[VARLEYHYD]

rev-erend said:

Answer probably here ..

http://www.varleyhyd.com/FJ062.asp#Fault%20codes

If not it is the manual at 230-250lb/ft


G

[Red Cabbage]

The image is not very clear but if you magnify this or print this Chimaera Torque settings table out it could prove useful.

http://www.parkersteve.dsl.pipex.com/images/torque...

Edited by Red Cabbage on Monday 23 March 21:32

[Rollcage]

Those torque settings are murder tight!Just tighten as much as you feasibly can ,and then get the long bar out!

[Jim Green]

Many Thanks Guys.

Jim

[rev-erend]

It's a similar torque figure on the rear hub nut on the wedge ..

commonly know as FBT

Fukcing bl00dy tight !

[Rollcage]

As in jumping on the handle of a 3/4" drive ratchet tight!And then some!

[Red Cabbage]

It's all about leverage.