plug spanner
plug spanner
Author
Discussion

hiltonig

Original Poster:

3,153 posts

239 months

Wednesday 25th March 2009
quotequote all
anyone suggest a good plug spanner, i have one supplied with a socket set and its not very good, any suggestions >?

Pupp

13,042 posts

303 months

Wednesday 25th March 2009
quotequote all
A 3/8 drive socket type works best on mine... 1/2 inch is too bulky

lewis_sharman

5,958 posts

222 months

Wednesday 25th March 2009
quotequote all
I got mine in a Socket set from Halfords, i think you can get them seperately aswell though. It has a rubber insert to grip the plug aswell so you can pull it out easily.

scotty_d

6,795 posts

225 months

Wednesday 25th March 2009
quotequote all
lewis_sharman said:
I got mine in a Socket set from Halfords, i think you can get them seperately aswell though. It has a rubber insert to grip the plug aswell so you can pull it out easily.
+1

GreenV8S

31,027 posts

315 months

Wednesday 25th March 2009
quotequote all
Get one with a hex on the outside so you can get an open ender onto it, also get a bar with an integral UJ rather than a separate T-bar and UJ.

Rum Runner

2,349 posts

248 months

Wednesday 25th March 2009
quotequote all
I have found that its also better if they are fairly thin walled.

WokingWedger

1,030 posts

236 months

Thursday 26th March 2009
quotequote all
Agree about the thin wall. I discovered that my socket was rubbing on the side of the casting 'pocket' and could not therefore tell how tight the plugs really were. I took the socket to a grinder to thin the wall down, and got a much more satisfying and correct 'feel' when tightening.

Andy JB

1,321 posts

250 months

Thursday 26th March 2009
quotequote all
You can use 1/2 or 3/8 sockets usually with proper plug socket with rubber take-up and extension bar with UJ. I have used 1/2 for past few years, but they are thick, so just replaced with 3/8 so i suggest thats your best option.

Job should easily take under an hour for all 8