Emerald EGT and map sensor
Discussion
Not got a map sensor (will get one at some point though!), but I do run EGT. To view the current value, go to live adjustments and click on one of the variables in the bottom-right hand corner and change it to EGT. My normal idle is around 400-450 degrees IIRC. At the moment I have the following adjustments:
degrees |enrichment
900 | 0
950 | 5
1000 | 15
1050 | 20
1100 | 30
I had TVR power's SC mapper (Frank) take a look at it and he seemed to think that the numbers were reasonable for an RV8, I haven't checked the temps at detonation yet though so not sure what temp this would occur at. If you find any more info, I'd love to hear!
degrees |enrichment
900 | 0
950 | 5
1000 | 15
1050 | 20
1100 | 30
I had TVR power's SC mapper (Frank) take a look at it and he seemed to think that the numbers were reasonable for an RV8, I haven't checked the temps at detonation yet though so not sure what temp this would occur at. If you find any more info, I'd love to hear!
Edited by 450Nick on Friday 27th March 12:46
350Matt said:
I used to run a MAP sensor for load sensing on my emeralded wedge it worked OK but the TPS gave better throttle response. Plus its far far easier to map a car with TPS
I reverted back to the TPS for the load and used the MAP just for baro correction in the end.
just got the EGT from Emerald and will fit tomorrow, yes i think ill use the map sensor for baro correctionI reverted back to the TPS for the load and used the MAP just for baro correction in the end.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


