clutch slipping... only 40'000 Miles
clutch slipping... only 40'000 Miles
Author
Discussion

doppioexpresso

Original Poster:

171 posts

214 months

Saturday 28th March 2009
quotequote all
hello everybody...

bought a chim 500 2 weeks ago. went to pick it up in london and drove it back to switzerland (600miles). already when I picked the car up in london I felt that the clutch was slipping in 4th and 5th. I know that when a clutch is dead, it usually does not last much longer than 100-200 miles to go totally.
Stangely, mine got better the more it was driven. when i flored it in 5th, it was slipping just a little bit. but after it slipped a bit, it is totaly fine. it does not slip at all.
when it is cole again. it will slipp slightly again...


WHAT THE HELL IS IT????

Thank your for your help

kevin63

4,661 posts

284 months

Saturday 28th March 2009
quotequote all
It is possible the clutch surface had glassed over and would not give %100 grip and with normal use for a time could come back to normal, another thing that could be possible is that if it has lived in London it could have been used a lot in slow moving traffic, this would shorten the life of a clutch. If you keep having trouble you could try bleeding the clutch system, this would be easy and cheap to do and would then rule out any problem in that area.

Oh, and congratulations.

MoreSteam

698 posts

221 months

Saturday 28th March 2009
quotequote all
I had the very same thing at 38000 miles. Apparently this is a common milage for the clutch to go. Sorry.frown

TJC46

2,199 posts

237 months

Saturday 28th March 2009
quotequote all
Possible oil contamination on the clutch face? Check for oil below the gearbox bellhousing.

doppioexpresso

Original Poster:

171 posts

214 months

Saturday 28th March 2009
quotequote all
thank you very much for all the usefull info... what do you mean by bleading out the system?


doppioexpresso

Original Poster:

171 posts

214 months

Saturday 28th March 2009
quotequote all
MoreSteam said:
I had the very same thing at 38000 miles. Apparently this is a common milage for the clutch to go. Sorry.frown
NOOOOOOOOOOOOOO!!!! you won't believe, but my garage said the same. then offered me a new clutch for £ 2'000... No joke!!!

If I do need a new clutch... what would be the best to buy in your oppinion?`

cheers

Dave 500

7,889 posts

273 months

Saturday 28th March 2009
quotequote all
Blimey I got 80K out of mine with a few track days and two cannonballs for good measure.

I've only had it replaced because I'm a tart and when having the engine out to make it all nice and shiny it was an extra £200.

40000 mile seems low to me but I guess it will depend on how its been driven.

smile

MoreSteam

698 posts

221 months

Saturday 28th March 2009
quotequote all
doppioexpresso said:
MoreSteam said:
I had the very same thing at 38000 miles. Apparently this is a common milage for the clutch to go. Sorry.frown
NOOOOOOOOOOOOOO!!!! you won't believe, but my garage said the same. then offered me a new clutch for £ 2'000... No joke!!!

If I do need a new clutch... what would be the best to buy in your oppinion?`

cheers
£2000 eek. Thats a bit steep. Mine was £650 fitted. It's for a 400HC though, which I believe is a smaller unit. The garage I deal with sourced the same as the original.

wheels1

209 posts

219 months

Sunday 29th March 2009
quotequote all
Drive the car around for a while,and see what happens, you may get lucky and it might just be because, it has not been used for a long time.

doppioexpresso

Original Poster:

171 posts

214 months

Sunday 29th March 2009
quotequote all
jep.... 650 sounds more like I like it....
will now take the thing apart and see what it is... if it really is the clutch I order one from tvrparts... for £311.- and put it in myself


doppioexpresso

Original Poster:

171 posts

214 months

Sunday 29th March 2009
quotequote all
wheels1 said:
Drive the car around for a while,and see what happens, you may get lucky and it might just be because, it has not been used for a long time.
exactely my plan :-)

450Nick

4,027 posts

243 months

Sunday 29th March 2009
quotequote all
£2000??? Are they having a laugh?! I got a Helix uprated clutch fitted to mine for £450 a couple of years ago - including the clutch!

doppioexpresso

Original Poster:

171 posts

214 months

Monday 30th March 2009
quotequote all
450Nick said:
£2000??? Are they having a laugh?! I got a Helix uprated clutch fitted to mine for £450 a couple of years ago - including the clutch!
Then it is probably worth it to rent a helicopter, have the car carried to england, have the clutch made and then fligh back ;-)

paulathome

686 posts

249 months

Monday 30th March 2009
quotequote all
As already posted above, it could be that the clutch plate is contaminated with oil because it gets better when driving which suggests that the contaminates are being burnt off with use.
It may be the input shaft bearing seal has failed and leaking ATF220 all over the clutch plate which is then burnt off with use. This happened to me and it is fairly obvious when you look under the car and spot the oil dispersed along the length of the chassis.
Look on the bright side, saves wax oiling.
Paul

doppioexpresso

Original Poster:

171 posts

214 months

Tuesday 31st March 2009
quotequote all
paulathome said:
As already posted above, it could be that the clutch plate is contaminated with oil because it gets better when driving which suggests that the contaminates are being burnt off with use.
It may be the input shaft bearing seal has failed and leaking ATF220 all over the clutch plate which is then burnt off with use. This happened to me and it is fairly obvious when you look under the car and spot the oil dispersed along the length of the chassis.
Look on the bright side, saves wax oiling.
Paul
I like you ;-) the glass IS half full... not half empty....

how did you solve your problem? just clean it with break cleaner? or did you replace something?

paulathome

686 posts

249 months

Tuesday 31st March 2009
quotequote all
Unfortunatley it was a gearbox out and new clutch and input shaft bearing seal replacement.
Did it on the drive which was a right performance. Been fine since however.
Paul.

Don

28,378 posts

315 months

Tuesday 31st March 2009
quotequote all
We had to replace the clutch in our Chimaera at about 45,000 miles.

The light that burns twice as bright burns half as long. And all that nonsense.


doppioexpresso

Original Poster:

171 posts

214 months

Tuesday 31st March 2009
quotequote all
paulathome said:
Unfortunatley it was a gearbox out and new clutch and input shaft bearing seal replacement.
Did it on the drive which was a right performance. Been fine since however.
Paul.
Chiuauiuaua!!!!!

doppioexpresso

Original Poster:

171 posts

214 months

Tuesday 31st March 2009
quotequote all
Don said:
We had to replace the clutch in our Chimaera at about 45,000 miles.

The light that burns twice as bright burns half as long. And all that nonsense.
NOOOOOOOOOOOO!!!!!!!

Don

28,378 posts

315 months

Tuesday 31st March 2009
quotequote all
doppioexpresso said:
Don said:
We had to replace the clutch in our Chimaera at about 45,000 miles.

The light that burns twice as bright burns half as long. And all that nonsense.
NOOOOOOOOOOOO!!!!!!!
Well it's a big powerful engine and TVR fitted a part made of cream cheese. It's unsurprising that it wears out in time. It's better than the bits they fitted to SP6 engines which, it would appear, were manufactured from dairy milk chocolate.

It really shouldn't cost £2K to fit a new clutch. A few hundred quid, yes, but not two thousand.