Vacuum tank for brake servo???
Vacuum tank for brake servo???
Author
Discussion

STE VR

Original Poster:

501 posts

237 months

Sunday 29th March 2009
quotequote all
Just been replacing some vacuum pipes from the plenum on 94 L 4.0HC pre-serp. Found the brake servo hose to be tee'd off. One goes to the servo the other goes to a vacuum tank in front of the radiator(behind grill). Is this an after market mod or was it standard fit at some point? It's definately nothing to do with the purge valve/canister system. I must admit the brakes were rather sharp.

Any help would be appreciated.

GreenV8S

31,027 posts

315 months

Sunday 29th March 2009
quotequote all
It's not standard, and not an addition I've ever seen. Is it definitely just an accumulator, no other connections or fittings anywhere?

STE VR

Original Poster:

501 posts

237 months

Sunday 29th March 2009
quotequote all
No, it is very strange. Its just a cylindrical tank with one hose connection to it. There are also three holes in the wing. One for the purge etc one for the servo and the third is for this hose going to the extra tank. The servo and tank hose are tee'd off by the plenum. Has got me a bit baffled as I've never seen this before. I couldn't decide if it was aftermarket because it does look like a TVR installation(ie bks to it, we'll just put it herehehe)