clutch replacement options
clutch replacement options
Author
Discussion

matt12023

Original Poster:

485 posts

227 months

Monday 6th April 2009
quotequote all
Hi

still a bit miffed my tvr as after the very expensive service and mot i was told the said garage that the master cylinder was leaking, so 70 quid later replaced that only to discover that its the slave thats leaking so thats to replace as well. so after all this the damn clutch has started slipping. its a 500 with 48k on the clock so i think the mileage is about right

other then say the usual tvr shops can anyone recommend where the best place to get one is

i plan to do this myself at some point soonish, can the box be dropped underneath or does the engine need to shift forward or out completely?

daz the plumber

14,997 posts

262 months

Monday 6th April 2009
quotequote all
i went down your route to find the local auto factors did not have a clue .keepaway from re lined clutch plates like (national).the clutch cover is pritty standard but the plate as a fine spline to suit the gearbox .i spent a fortune in the end and got mine from tvr shop (borg and beck ), don`t forget a new clutch fork , well worth replacing .

Blackpool Rocker

381 posts

253 months

Monday 6th April 2009
quotequote all
Did my clutch last year,and, to be honest not a bad job to do.
removed the gearbox from under the car after removing it from
the bell housing.
done it from start to finish on a saturday morning although I
did have use of a vehicle ramp that made the job so much easier.
The only reason the clutch was changed was because it had gone very
stiff & heavy. I fitted a borg & beck clutch kit from memory.


Tvrjock

350 posts

223 months

Monday 6th April 2009
quotequote all
Hi Matt
Replaced my clutch last year try rimmer brothers they were far cheaper than anyone else, took me 2 days with axle stands and trolly jack.
Graeme