How much torque to turn the crank?
Discussion
I am in the middle of an engine rebuild at the moment and I am putting the end caps back on with new main bearings. I have checked the clearances with Plastiguage and they are all fine.
There is some binding with the third cap at the moment which I believe is due to interference from the side. I have that out so I currently have caps 1,2,4 and 5 at correct torque. It feels stiff though and though there is no binding; it takes 43 Nm of Torque to turn the crank. Is this right?
I should have checked the feel of the old one before taking it out. I expect Quinny will know the answer to this but wondering if anyone else can help?
There is some binding with the third cap at the moment which I believe is due to interference from the side. I have that out so I currently have caps 1,2,4 and 5 at correct torque. It feels stiff though and though there is no binding; it takes 43 Nm of Torque to turn the crank. Is this right?
I should have checked the feel of the old one before taking it out. I expect Quinny will know the answer to this but wondering if anyone else can help?
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


