Serpentine Oil pump fitment, advice appreciated
Discussion
Sorry cant get the picks of the PDF
hope this helps
1. Thoroughly clean oil pump drive gear, cover
plate, rotors and housing. Remove all traces of
Loctite from cover plate securing screws;
ensure tapped holes in timing cover are clean
and free from oil.
2. Check mating surfaces of cover plate, rotors
and housing for scoring.
3. Assemble rotors and oil pump drive gear in
housing ensuring that reference marks are
aligned.
4. Using feeler gauges, check clearance between
teeth of inner and outer rotors:
Maximum clearance = 0.25 mm (0.01 in)
5. Remove oil pump drive gear, check depth of
any wear steps on gear teeth:
Wear step maximum depth = 0.15 in (0.006 in)
6. Place a straight edge across housing.
7. Using feeler gauges, check clearance between
straight edge and rotors:
Maximum clearance = 0.1 mm (0.004 in
Refit of pump
Oil pump - refit
1. Lubricate rotors, oil pump drive gear, cover
plate and housing with engine oil.
2. Assemble rotors and drive gear in housing
ensuring that reference marks are aligned.
3. Position cover plate to housing.
4. Apply Loctite 222 to threads of cover plate
screws and bolt.
5. Fit cover plate screws and bolt and tighten to:-
Screws - 4 Nm (3 lbf.ft)
Bolt - 8 Nm (6 lbf.ft)
6. Fit timing cover.
If you need any more pm me and i could email the overhaul manual to you, cheers Rick
hope this helps
1. Thoroughly clean oil pump drive gear, cover
plate, rotors and housing. Remove all traces of
Loctite from cover plate securing screws;
ensure tapped holes in timing cover are clean
and free from oil.
2. Check mating surfaces of cover plate, rotors
and housing for scoring.
3. Assemble rotors and oil pump drive gear in
housing ensuring that reference marks are
aligned.
4. Using feeler gauges, check clearance between
teeth of inner and outer rotors:
Maximum clearance = 0.25 mm (0.01 in)
5. Remove oil pump drive gear, check depth of
any wear steps on gear teeth:
Wear step maximum depth = 0.15 in (0.006 in)
6. Place a straight edge across housing.
7. Using feeler gauges, check clearance between
straight edge and rotors:
Maximum clearance = 0.1 mm (0.004 in
Refit of pump
Oil pump - refit
1. Lubricate rotors, oil pump drive gear, cover
plate and housing with engine oil.
2. Assemble rotors and drive gear in housing
ensuring that reference marks are aligned.
3. Position cover plate to housing.
4. Apply Loctite 222 to threads of cover plate
screws and bolt.
5. Fit cover plate screws and bolt and tighten to:-
Screws - 4 Nm (3 lbf.ft)
Bolt - 8 Nm (6 lbf.ft)
6. Fit timing cover.
If you need any more pm me and i could email the overhaul manual to you, cheers Rick
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



ops: