two speed fan mod question !
Discussion
I have the two-speed fan mod and was wondering what settings to leave the thermostats on.
I don’t entirely trust the temp gauge on the dash. I was told they can run about 10 degrees out !
( don’t know if that’s true or not).
My temp currently doesn’t get any higher than about 75 (on the dash , so that could be 85 then !). Its still coolish outside plus I now have a totally de-catted system.
I currently have it set on 40 degree half speed and about 75 to 80 degree full speed.
I’m not sure I fully understand the temperature charts in the bible
( page 141) .
I think I have a good balance with half speed almost all the time then full speed when hot .
I just wondered what other people where leaving them set on. I dont have a over heating problem and
I know too hot is a lot worse than too cold but I want it set for optimum efficency . My mpg could suffer if the engine doesn’t get hot enough.
I don’t entirely trust the temp gauge on the dash. I was told they can run about 10 degrees out !
( don’t know if that’s true or not).My temp currently doesn’t get any higher than about 75 (on the dash , so that could be 85 then !). Its still coolish outside plus I now have a totally de-catted system.

I currently have it set on 40 degree half speed and about 75 to 80 degree full speed.
I’m not sure I fully understand the temperature charts in the bible
( page 141) . I think I have a good balance with half speed almost all the time then full speed when hot .
I just wondered what other people where leaving them set on. I dont have a over heating problem and
I know too hot is a lot worse than too cold but I want it set for optimum efficency . My mpg could suffer if the engine doesn’t get hot enough.

The sensors are clamped to the bottem hose under the aluminium expansion tank ( blue twist cap). The thermostate box and dials are them selvs tie wrapped to this tank. if that helps ? , the top dial has a red dot at the top and the bottem one has a green dot. im pritty sure from memory its the bottem dial that kicks in the half speed.
The bottom hose temperature gives you the best signal to control the fans because it tells you whether there is enough ram air flow. However, it seems to me that you have the 'half speed' sensor set far too low. You don't want or need the fans on once you are above 40 mph or so - they're doing nothing but wear themselves out. You should set the 'half speed' switch so that it brings the fans on as the temperature at the bottom hose reaches about 10C below your desired engine temperature. This should keep the fans off while you're moving but bring them on promptly as you stop.
Nothing the fans do will cause the engine to run too cold, unless you have a faulty stat.
Nothing the fans do will cause the engine to run too cold, unless you have a faulty stat.
GreenV8S said:
The bottom hose temperature gives you the best signal to control the fans because it tells you whether there is enough ram air flow. However, it seems to me that you have the 'half speed' sensor set far too low. You don't want or need the fans on once you are above 40 mph or so - they're doing nothing but wear themselves out. You should set the 'half speed' switch so that it brings the fans on as the temperature at the bottom hose reaches about 10C below your desired engine temperature. This should keep the fans off while you're moving but bring them on promptly as you stop.
Nothing the fans do will cause the engine to run too cold, unless you have a faulty stat.
thanks , what is a normal desired engin temp though 80 degrees c ?. should i set the half speed to 70 c and full at 90 c ?.Nothing the fans do will cause the engine to run too cold, unless you have a faulty stat.
do you think that sounds about right?.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



