Serp Oil Change - Prime Pump?
Serp Oil Change - Prime Pump?
Author
Discussion

debaron

Original Poster:

878 posts

228 months

Tuesday 14th April 2009
quotequote all

Going to do Oil + Filter this weekend - Been reading on here about possible zero oil pressure after a change.

What's the best way to avoid having to remove and pack the Oil Pump?


Someone mentioned filling the Oil Filter with oil first but also posted was a recommendation not to!

Mine's a Serp 400 - Is it true Serps suffered less from this problem?



Cheers


Ryan

dogbucket

1,256 posts

232 months

Wednesday 15th April 2009
quotequote all
Yes the serps have a different pump so dont really get that problem. I did pre fill the filter and had no problems. But as a precaution I felt it was prudent to not leave it sitting too long with no oil in it just in case, so got it refilled and started a soon as possible.

chrispitman

742 posts

285 months

Wednesday 15th April 2009
quotequote all
As above just fill the filter with oil when you change, it should prime pretty quick. When I did an engine rebuild thats all I did. Just blip the revs when you start the engine gets the oil moving quicker and watch the oil warning light goes out after a few seconds, then you should see the oil gauge showing some presure but these are slow.

Chimjunkie

2,879 posts

242 months

Wednesday 15th April 2009
quotequote all
I think the priming problems with the serp are more if the engine has been stood with no oil or the pump has been dismantled and cleaned. I used a cheap electric drill-driven pump off ebay to force oil up through the oil pressure sender hole. This got the oil pump going after my strip down.

Chassis 33

6,194 posts

313 months

Wednesday 15th April 2009
quotequote all
As above, you shouldn't really have a problem, but if you're really concerned, take the plugs out and crank the engine until the oil pressure ligh goes out.

Regards
Iain

debaron

Original Poster:

878 posts

228 months

Wednesday 15th April 2009
quotequote all

Thanks guys,

feeling a bit more confident about it now!



Ryan

Slikk

2,135 posts

274 months

Wednesday 15th April 2009
quotequote all
I have left my Serp overnight with the sump empty and the filter removed. Never had a problem.