Trumpet base gasket?
Trumpet base gasket?
Author
Discussion

paulathome

Original Poster:

686 posts

249 months

Wednesday 15th April 2009
quotequote all
I have a high pitched........ahem......weeeeeeeeeeeeeeeeee coming from the rear of the plenum on the over-run which started a couple of weeks ago and is now audible at tick over. Whipped the plenum off and resealed it with blue gasket glue. However its still doing it so I suspect a leak between the trumpet base and inlet manifold. Engine is running fine so it can only be a tiny leak.
Could anyone tell me if it's a gasket at this joint or more gasket glue?
TIA.
Paul.

lwt

316 posts

315 months

Wednesday 15th April 2009
quotequote all
Could also be around the housing for the stepper motor etc. Get a length of flexible tubing like washer tube and use it like a stethoscope to find the source.

Ian

debaron

878 posts

228 months

Thursday 16th April 2009
quotequote all

Hi Paul,

There's no gasket at this point - just a good bit of blue hylomar.

However if you are going to remove Inlet Manifold / Trumpet Base, get yourself one of these trumpet base gaskets:

http://www.sc-power.co.uk/SC%20Power%20Engine%20Mo...

Did mine the other day and Plenum is much cooler to the touch plus helps seal and gaps and eliminate possible noises!



Ryan

spend

12,581 posts

282 months

Thursday 16th April 2009
quotequote all
If you had a serious leak it would be likely the engine runs like poo? Even small leaks have quite major impacts on tickover (like frequent stalling)..

Just seems odd that you say its running fine....