Help - Missfire above 3000 rpm when hot!
Discussion
There has been a few topics on the forums about what happens above a 3000 rpm. I have a missfire when the car gets up to operating temp and above 3000 rpm. Below 3000 and she's fine, cold and she's fine all through the rev range. I just cant seem to find the problem. Ignition system is only 12 months old and all decent kit from ACT ie Magnecor etc etc. I intend to change plugs tomorrow morning but they look fine and I doubt if they are the problem though.
Can anybody tell me what happens above 3000 rpm regarding the ECU - I know it goes to "open" rather than "closed" loop control but there doesnt seem much definition of this.
Im supposed to be at Austec tomorrow but I cant see this happening
Can anybody tell me what happens above 3000 rpm regarding the ECU - I know it goes to "open" rather than "closed" loop control but there doesnt seem much definition of this.
Im supposed to be at Austec tomorrow but I cant see this happening

It goes open loop at 3400 rpm, but the fueling would have to be a long way out for it to actually mis fire. It can happen if the fuel pump delivery is low, but the engine goes flat long before you reach a misfire as it leans out. Id check you dont have an HT fault first, typically things like non OEM rotor arm. Its worth checking plug colours, as if one mis firing, the plugs should be blacker on one bank as the ECU mistakes the misfire for a lean mixture and throws in more fuel to compensate, but can only do it one one bank at a time. Othewise Id of thought Austec's would find it pretty quicky, as theres no rocket science here !
Symonab said:
There has been a few topics on the forums about what happens above a 3000 rpm. I have a missfire when the car gets up to operating temp and above 3000 rpm. Below 3000 and she's fine, cold and she's fine all through the rev range. I just cant seem to find the problem. Ignition system is only 12 months old and all decent kit from ACT ie Magnecor etc etc. I intend to change plugs tomorrow morning but they look fine and I doubt if they are the problem though.
Can anybody tell me what happens above 3000 rpm regarding the ECU - I know it goes to "open" rather than "closed" loop control but there doesnt seem much definition of this.
Im supposed to be at Austec tomorrow but I cant see this happening
You and me both, Symonab. Can anybody tell me what happens above 3000 rpm regarding the ECU - I know it goes to "open" rather than "closed" loop control but there doesnt seem much definition of this.
Im supposed to be at Austec tomorrow but I cant see this happening


Replaced the ECU Coolant Temperature sensor and rotor arm yesterday (both genuine LR parts), result = no difference, still misfires when warmed up and under load at 3000 rpm (tickover is better though). Have been pointed in the direction of ignition timing and plug extenders. Problems with locating TDC and distributor settings (as described in Steve Heath's bible). Don't know how the temperature variation would effect this though.
I've also noticed the fuel tank is trying very hard to implode with near perfect vacuum conditions forming after a run, the inward air rush when releasing the cap is very dramatic.
Good luck with your rolling road session tomorrow, if it happens. be very interested to hear what Austec say.
Edited by davep on Friday 17th April 20:48
Hi Dave,
I suppose you've run it with the fuel cap off to see if that makes a difference? There is the obvious safety considerations with running with no cap but a quick hoon shouldn't hurt. Just wonder if the fuel pump is having to pull against a strong vacuum all the time resulting in weak fuel pressure?
Like the ever knowledgeable Blitzracing says - the plugs would indicate this though.
Ryan
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


