Peak Torque for a 500, what revs
Discussion
I did have it on the RR as a standard car about three years ago as standardand the torque peaked at around 4250RPM at 295Lbs/Ft with 259BHP but car had a blocked injector at the time.
I had it back on the RR last week, but car now has some mods. Mark Adams best guess chip, ACT trumpets + V8D Steath that I just fitted (hence the recent RR session).
It is making 343 LBS/FT at 4160 RPM.
They also tested the fuelling and this starts to go too lean at 4500 RPM at which point torque drops off fast.
Max HP was 307.3 at 5200 RPM.
I am going to give Mark Adams a call when I get a chance to see if it is possible to do anything further with the fuelling.
I would be interested in any comments on this thread on what is **normal**.
I had it back on the RR last week, but car now has some mods. Mark Adams best guess chip, ACT trumpets + V8D Steath that I just fitted (hence the recent RR session).
It is making 343 LBS/FT at 4160 RPM.
They also tested the fuelling and this starts to go too lean at 4500 RPM at which point torque drops off fast.
Max HP was 307.3 at 5200 RPM.
I am going to give Mark Adams a call when I get a chance to see if it is possible to do anything further with the fuelling.
I would be interested in any comments on this thread on what is **normal**.
mattrosersv said:
It is making 343 LBS/FT at 4160 RPM.
They also tested the fuelling and this starts to go too lean at 4500 RPM at which point torque drops off fast.
Max HP was 307.3 at 5200 RPM.
Thats almost exactly the same figures and fuelling issues as my original rebuild gave, with mc1 cam and no other mods.They also tested the fuelling and this starts to go too lean at 4500 RPM at which point torque drops off fast.
Max HP was 307.3 at 5200 RPM.
ETA you could try increasing the fuel rail pressure, but it didn't cure it with mine at 43 psi so I replaced the jets with Bosch redtops. With the Dollar exchange rate at the time worked out cheaper than having the old one cleaned, but you will need to remap it.
Edited by Bluebottle on Monday 20th April 14:21
The fuel pressure is always a bit of a chestnut
Regulator looks at a spot pressure (vacuum) from a point in the plenum. What you really want is the fuel pressure to be raised v a particular injector relative to the pressure in the particular port it is spurting into.. Due to the breathing some ports will be sucking, some blowing & some doing FA... even if you accept that the spot reading from the plenum is the 'average'
One of the reasons that a few of us support the idea of sequential injection - so that you can always inject against a port in the same phase
Regulator looks at a spot pressure (vacuum) from a point in the plenum. What you really want is the fuel pressure to be raised v a particular injector relative to the pressure in the particular port it is spurting into.. Due to the breathing some ports will be sucking, some blowing & some doing FA... even if you accept that the spot reading from the plenum is the 'average'One of the reasons that a few of us support the idea of sequential injection - so that you can always inject against a port in the same phase

Gassing Station | Chimaera | Top of Page | What's New | My Stuff




