Another top end tap!
Discussion
Car just returned from a bodyshop where it has been for over two years (long story, please don't ask) and during that time I am sure that the engine was never turned over.
There is a tapping noise, which sounds as if it is emanating from the cam/follower area and power is way down, the unit has only covered about 6000miles!
So far I have had the coolant checked and been assured that there is no head gasket failure, compressions are all between 180 and 190psi, oil pressure is good, ignition checks out OK and all the thrust pads are still attached to the rockers! There was a crack in an exhaust manifold gasket, now replaced, HC reading is too high! plugs are a little sooty so far I am down in the valley, visually checked out all the lobes and everything looks OK.
Does anyone know if lifters can fail through having been held compressed for such a long period?
Any other theories/experiences that you could share with me?
Thank you.
There is a tapping noise, which sounds as if it is emanating from the cam/follower area and power is way down, the unit has only covered about 6000miles!
So far I have had the coolant checked and been assured that there is no head gasket failure, compressions are all between 180 and 190psi, oil pressure is good, ignition checks out OK and all the thrust pads are still attached to the rockers! There was a crack in an exhaust manifold gasket, now replaced, HC reading is too high! plugs are a little sooty so far I am down in the valley, visually checked out all the lobes and everything looks OK.
Does anyone know if lifters can fail through having been held compressed for such a long period?
Any other theories/experiences that you could share with me?
Thank you.
How long did you allow the engine to run after removing car from the workshop? did you not try a fresh oil & filter change 1st than take the engine up to operating temperature or better still for a drive? as tappets tend to bleed down over long periods creating the noise you describe,you have to allow time for the oil pressure to pump up the lifter thus taking up excess clearance(excess noise)and after that length of standing idle a lube service is highly recommended 

Gassing Station | Chimaera | Top of Page | What's New | My Stuff



