Limited handbrake travel
Discussion
The handbrake on my recently bought Chimaera is virtually useless. I've had the calipers off and there is nothing amiss there, so I dropped the exhaust to replace the cable. With the cable removed, the handbrake lever only comes up 3 clicks before the bottom part of the lever (that the cable attaches to) hits the flanged retainer that holds the gear lever into the tailshaft housing. The cable has therefore been seeing little or no tension before the lever runs out of travel. Is this a familiar problem? The obvious solution would be to lower the gearbox in the chassis by 5-6mm. Anybody done this, if so what's the best way?
Seems to be a 'TVR Trait' , mines the same . Try pushing hard on the brake pedal as you apply the hand brake , it'll give you a wee bit more but not enough to stop you on a steep slope.
I've not got under there to look but I think that the cable pick up point needs to be closer to the fulcrum to give a greater mechanical advantage
Nick............
I've not got under there to look but I think that the cable pick up point needs to be closer to the fulcrum to give a greater mechanical advantage
Nick............
That would work, Nick, and also lift the pin that the cable attaches to enough the clear the gearbox. The alternative would be to cut the bottom off the lever below the fulcrum and weld it angled a bit further back. Either would be a b...er to do as the lever would have to come out. I'm not too bothered about changing the angle of the driveline by a tiny amount - the propshaft UJs work at much bigger angles on live axle cars. Shorter rubber gearbox mounting bobbins would be the easiest way. Surely they can't all be like this - none of them would ever pass an MOT and the same bits seem to work OK in Sierras.
Thought you might be interested in an update. I found a place on t'internet that does rubber bobbins in every imaginable combination or diameter, thickness and thread. Fitted a thinner than standard one on the right side of the gearbox mount and a thicker than standard one on the left side, which had the effect of moving the back of the gearbox slightly to the right and down. The bottom of the handbrake lever just clears the gearbox now and, guess what, the handbrake works!
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


