Refilling the cooling system!
Refilling the cooling system!
Author
Discussion

bjarkes

Original Poster:

122 posts

215 months

Monday 20th April 2009
quotequote all
Hi Guys

The raditor is in for repair and I was reading the bibel about filling the system again.
It´s not quit clear to me, but after you have filled the tank (By the way, how on earth do you get the metal cap on the tank of???) are you starting up the engine and then refilling with the engine running and bleeding the radiator?

PS: I have a 2 tank system

HRG

72,863 posts

270 months

Monday 20th April 2009
quotequote all
I used a pickaxe to open my header tank. That's not as brutal as it sounds, it's a bloody long lever, fits the cap well and doesn't flex at all.

AlexanderV8

1,498 posts

234 months

Monday 20th April 2009
quotequote all
Hello bjarkes,
Here is a reply I gave once before on this. Hope it helps. Don't forget the radiator bleed step - it is important to ensure the air is out of the system, just like you would bleed the central heating radiators in you house to get proper flow around the system:

You need to check & fill the system from the swirl tank but first you need to ensure there is no air in the system (as happens when there is a leak somewhere). It is explained in the handbook (if you got one with the car). The way I do it is:
1). Ensure coolant is cool and remove expansion tank cap.
2). Turn heater control to hot.
3). Fill expansion tank with coolant to about half way up.
4). Remove brass screw on top of swirl tank. Mine was stuck rigid when I first got the car and no matter how much leverage I tried applying, it wasn't going to shift before I would have distorted the can, so I (very carefully )applied a blowtorch to it (avoiding any hoses or plastic parts etc. with heat shields). It didn't take long to break the seal and then it unscrewed easily by inserting the tip of a large flat-bladed screwdriver sideways and applying leverage. It always opens easily now every time.
5). Fill swirl pot to the top with coolant.
6). Undo bleed plug on top of radiator (might be on either side!). See what comes out! If air comes out, wait until only coolant flows with no air. When all air has gone, retighten radiator bleed plug.
7). Refill swirl tank with coolant to the top. (The level will have dropped as the coolant comes out of the radiator bleed).
8). Replace swirl tank brass screw.

Basically, that is the process I use. You should then run the engine until the fans kick in, wait for it to cool and then repeat the process. This is to try & purge the system of any air that may have been trapped in the heater matrix etc.

If the car susequently dumps some coolant on the garage floor, don't worry, it is it's way of naturally finding it's own level in the expansion tank. Mine runs only about an inch fron the bottom with no problems. Excess coolant is evacuated via the blue expansion tank cap.

Cheers,
Mick

bjarkes

Original Poster:

122 posts

215 months

Monday 20th April 2009
quotequote all
Great, thanks alot.

Bjarke